Use of a Novel In Situ Hardening Biphasic Alloplastic Bone Grafting Material for Guided Bone Regeneration Around Dental Implants: A Prospective Case Series
- 30 November 2020
- journal article
- research article
- Published by Wiley in Clinical Advances in Periodontics
- Vol. 12 (1) , 12-16
Abstract
Introduction: The novel bioresorbable polymer poly (lactide‐co‐glycolic acid) (PLGA) coated biphasic calcium phosphate material (BCP) hardens into a stable and porous hard tissue scaffold when exposed to body fluids. The self‐containable, stable bone graft material might be beneficial for facilitating guided bone regeneration (GBR) around dental implants, especially for a defect with an absence of bony wall(s). The aim of this prospective case series is to evaluate the post‐surgical implant survival and success where the in situ hardening BCP was used for GBR around dental implants.Case Series: Ten patients received 13 implants with simultaneous bone augmentation. Dehiscence and/or fenestration type of bony defect was detected in nine surgical sites, and three surgical sites exhibited a suprabony defect. In nine out of the 13 implants, a membrane was used in conjunction with the bone grafting.Patients were evaluated at the day of the surgery as well as 2 weeks, and 1, 3, 6, and 12 months postoperatively. All post‐surgical wounds were uneventfully healed. Radiographic bone levels showed stability over time with an average bone loss/remodeling of 0.19 ± 0.6 mm (range, −0.5‐1.5 mm) from implant placement to the last follow‐up at 12 months. All implants survived after 12 months.Conclusions: Implant placement with simultaneous bone grafting using the in situ hardening BCP, was shown to be a viable and safe procedure with stable clinical and radiographic results over the follow‐up period. Further long‐term studies are warranted, however, the combination of the ease of handling and the favorable results are promising.Keywords
This publication has 12 references indexed in Scilit:
- Influence of wound closure on volume stability with the application of different GBR materials: an in vitro cone-beam computed tomographic studyJournal of Periodontal & Implant Science, 2019
- Lateral alveolar ridge augmentation procedure using subperiosteal tunneling technique: a pilot studyMaxillofacial Plastic and Reconstructive Surgery, 2018
- Human Studies of Vertical and Horizontal Alveolar Ridge Augmentation Comparing Different Types of Bone Graft Materials: A Systematic ReviewJournal of Oral Implantology, 2018
- Influence of wound closure on the volume stability of particulate and non‐particulate GBR materials: an in vitro cone‐beam computed tomographic examination. Part IIClinical Oral Implants Research, 2016
- Influence of blinded wound closure on the volume stability of different GBR materials: an in vitro cone‐beam computed tomographic examinationClinical Oral Implants Research, 2015
- Long-term Stability of Early Implant Placement with Contour AugmentationJournal of Dental Research, 2013
- Evaluation of moldable, in situ hardening calcium phosphate bone graft substitutesClinical Oral Implants Research, 2011
- Long‐Term Success of Implants Replacing a Single MolarJournal of Periodontology, 2006
- Evaluation of Long‐Term Implant SuccessJournal of Periodontology, 2005
- Factors Affecting the Outcomes of Coronally Advanced Flap Root Coverage ProcedureJournal of Periodontology, 2005