Ultrahigh-strength low carbon steel obtained from the martensitic state via high pressure torsion
Authors:
- T. MüllerTMT. Müller
- M.W. KappMKM.W. Kapp
- A. BachmaierABA. Bachmaier
- P. FelferPFP. Felfer
- R. PippanRPR. Pippan
- 1 March 2019
- journal article
- research article
- Published by Elsevier in Acta Materialia
- Vol. 166, 168-177
Abstract
No abstract availableKeywords
Funding Information
- European Research Council under ERC (340185)
- Helmholtz Association (I-20170215 EC)
This publication has 56 references indexed in Scilit:
- High temperature micropillar compression of Al/SiC nanolaminatesActa Materialia, 2013
- Development of a New Testing Procedure for Performing Tensile Tests on Specimens with Sub-Millimetre DimensionsJournal of Testing and Evaluation, 2013
- Characterization of the fracture toughness of micro-sized tungsten single crystal notched specimensPhilosophical Magazine, 2012
- Compressive flow behavior of Al–TiN multilayers at nanometer scale layer thicknessActa Materialia, 2011
- Atomic-scale mechanisms of deformation-induced cementite decomposition in pearliteActa Materialia, 2011
- The mechanism of formation of nanostructure and dissolution of cementite in a pearlitic steel during high pressure torsionActa Materialia, 2003
- The mechanical properties of the nanocrystalline layer on the surface of railway tracksMaterials Science and Engineering: A, 2001
- Martensite in steel: strength and structureMaterials Science and Engineering: A, 1999
- Two-dimensional detector software: From real detector to idealised image or two-theta scanHigh Pressure Research, 1996
- Influence of severe plastic deformation on structure and phase composition of carbon steelNanostructured Materials, 1994