Optimization of Hydrophobic Coating Production by Pechini Method on Modified Aluminum Surface
Open Access
- 12 April 2023
- journal article
- research article
- Published by Instituto de Quimica - Univ. Federal do Mato Grosso do Sul in Orbital: the Electronic Journal of Chemistry
- Vol. 15 (1) , 31-37
Abstract
To fabricate a hydrophobic coating using the sol-gel method (Pechini), an experimental design using the drying time and chemicals ratio as variables was developed. The coating was deposited on an aluminum substrate (AA6061-T6) treated by acid solution or anodization method. The surface wettability was measured using a goniometric instrument. Coatings were fabricated using different numbers of layers, heating rates, and drying temperatures, and their morphologies were observed using visual analysis and scanning electron microscopy. The use of anodization treatment with a furnace ramp of 1 °C min-1, a drying temperature of 220 °C ± 10 °C, and single-layer application, produced a coating free of visible flaws and apparent damage. The coating was obtained with a 15:1 glycerin:citric acid ratio and sample pre-polymerization in the drying oven for 1 hour at 100 °C resulted in the highest contact angle, 62° ± 2°, which meets the ASTM D-7334-08 standard for a hydrophobic surface.Keywords
This publication has 40 references indexed in Scilit:
- Fabrication of superhydrophobic coating from non-fluorine siloxanes via a one-pot sol–gel methodJournal of Materials Science, 2018
- Handbook of Sol-Gel Science and Technology2018
- Self‐Restoration of Superhydrophobicity on Shape Memory Polymer Arrays with Both Crushed Microstructure and Damaged Surface ChemistrySmall, 2016
- A Facile, Multifunctional, Transparent, and Superhydrophobic Coating Based on a Nanoscale Porous Structure Spontaneously Assembled from Branched Silica NanoparticlesAdvanced Materials Interfaces, 2015
- The influence of the hydrophobic agent, catalyst, solvent and water content on the wetting properties of the silica films prepared by one-step sol–gel methodApplied Surface Science, 2015
- Preparation of silane-functionalized silica films via two-step dip coating sol–gel and evaluation of their superhydrophobic propertiesApplied Surface Science, 2014
- A biodegradable thermoset polymer made by esterification of citric acid and glycerolJournal of Biomedical Materials Research Part A, 2013
- Study on fabrication of the superhydrophobic sol–gel films based on copper wafer and its anti-corrosive propertiesApplied Surface Science, 2012
- Superhydrophobic sol–gel nanocomposite coatings with enhanced hardnessApplied Surface Science, 2011
- The effect of composition variables on precursor degradation and their consequence on Nb2O5 film properties prepared by the Pecchini MethodJournal of Sol-Gel Science and Technology, 2006