Strain-Rate-Dependent Thermo-Microstructural Evolution in Fe-Mn-Si Shape Memory Alloys Under Cyclic Tensile Training Process
Open Access
Abstract
Iron-based shape memory alloys (Fe-SMAs) are promising for structural retrofitting because of their low cost, corrosion resistance, and manufacturability. However, the effect of strain rate on the coupled thermo-microstructural evolution during cyclic training remains underexplored. In this study, samples underwent cyclic tensile training at quasi-static and impact strain rates. After each cycle, DSC was adopted to obtain transformation temperatures and enthalpies, and selected cycles were characterized by EBSD (KAM and IPF) to quantify phase fractions and variant statistics. Results show tensile loading shifts transformation temperatures, with the principal difference between regimes appearing in the evolution of martensite finish temperature. Under impact loading, the transformation enthalpy increases more rapidly (0.18 to 0.8 J/g in absolute value), and the driving force decreases more markedly by the fourth cycle (−0.0578 to −0.1117 J/g), indicating faster thermodynamic changes at high strain rates. Internal stress and dislocation storage accumulate faster under impact, lowering the effective stress (−17.01 MPa) for transformation and promoting martensite nucleation/growth. EBSD reveals increasing lattice distortion; in impact-trained samples, single-variant martensite and higher stored energy reduce interface resistance and enable elastic energy release, accelerating transformation and improving shape recovery.Keywords
Funding Information
- China Postdoctoral Science Foundation (2025M784421)
- National Natural Science Foundation of China (12402464)
- Fundamental Research Funds for the Central Universities (G2024KY05105)
- Basic Research Programs of Taicang (TC2024JC24)
This publication has 45 references indexed in Scilit:
- Mechanical properties and constitutive models of Fe-SMA under steady-state fireConstruction and Building Materials, 2025
- Experimental study and design recommendations on Fe-SMA-steel bonded joints subjected to water immersionConstruction and Building Materials, 2025
- Effect of elevated temperature on the bond behaviour of adhesive shear joints between glass substrate and iron-based shape memory alloy stripConstruction and Building Materials, 2024
- NiTiCu shape memory alloys with ultra-low phase transformation range as solid-state phase change materialsActa Materialia, 2023
- Experimental investigation on debonding behavior of Fe-SMA-to-steel jointsConstruction and Building Materials, 2022
- Uniaxial behavior of pre-stressed iron-based shape memory alloy rebars under cyclic loading reversalsConstruction and Building Materials, 2022
- Shape memory alloy reinforcement for strengthening and self-centering of concrete structures—State of the artConstruction and Building Materials, 2022
- Low-cycle fatigue life and plasticity mechanisms of a Fe−15Mn−10Cr−8Ni−4Si seismic damping alloy under cyclic loading at various temperaturesActa Materialia, 2021
- A comparative study between Fe-SMA and CFRP reinforcements for prestressed strengthening of metallic structuresConstruction and Building Materials, 2019
- Reversible Characteristics and Cycling Effects of the ε ↔ γ Martensitic Transformations in Fe-Mn-Cr Twip/Trip SteelsJournal of Materials Engineering and Performance, 2014