Examination of the process of damaging the top covering layer of a conveyor belt applying the FEM
Authors:
- Daniela MarasováDMDaniela Marasová
- Ľubomír AmbriškoĽAĽubomír Ambriško
- Miriam AndrejiováMAMiriam Andrejiová
- Anna GrinčováAGAnna Grinčová
- 1 December 2017
- journal article
- research article
- Published by Elsevier in Measurement
- Vol. 112, 47-52
Abstract
No abstract availableKeywords
Funding Information
- European Regional Development Fund
This publication has 13 references indexed in Scilit:
- Failure analysis of belt conveyor damage caused by the falling material. Part II: Application of computer metrotomographyEngineering Failure Analysis, 2013
- The Modeling and Simulating of Conveyor Belt Based on ADAMSAdvanced Materials Research, 2012
- Indentation Rolling Resistance of Conveyor Belts Based on Maxwell ModelAdvanced Materials Research, 2012
- Virtual Prototype Modeling and Starting Method of Belt ConveyorApplied Mechanics and Materials, 2011
- Parametric Design on Belt Conveyor Drums Based on VBAAdvanced Materials Research, 2010
- Problems of numerical simulation of stress and strain in the area of the adhesive-bonded joint of a conveyor beltArchives of Civil and Mechanical Engineering, 2009
- A Comparative Study of Several Material Models for Prediction of Hyperelastic Properties: Application to Silicone‐Rubber and Soft TissuesStrain, 2006
- Modelling rolling contact phenomena in a pouch belt conveyor systemWear, 2006
- Observation and modeling of the anisotropic visco-hyperelastic behavior of a rubberlike materialInternational Journal of Solids and Structures, 2006
- Laboratory simulation of the wear process of belt conveyor rollersWear, 1993