Microstructural Characterization of TiC-Reinforced Metal Matrix Composites Fabricated by Laser Cladding Using FeCrCoNiAlTiC High Entropy Alloy Powder
Open Access
- 17 July 2021
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 11 (14) , 6580
Abstract
TiC-reinforced metal matrix composites were fabricated by laser cladding and FeCrCoNiAlTiC high entropy alloy powder. The heat of the laser formed a TiC phase, which was consistent with the thermodynamic calculation, and produced a coating layer without interfacial defects. TiC reinforcing particles exhibited various morphologies, such as spherical, blocky, and dendritic particles, depending on the heat input and coating depth. A dendritic morphology is observed in the lower part of the coating layer near the AISI 304 substrate, where heat is rapidly transferred. Low heat input leads to an inhomogeneous microstructure and coating depth due to the poor fluidity of molten pool. On the other hand, high heat input dissolved reinforcing particles by dilution with the substrate. The coating layer under the effective heat input of 50 J/mm2 had relatively homogeneous blocky particles of several micrometers in size. The micro-hardness value of the coating layer is over 900 HV, and the nano-hardness of the reinforcing particles and the matrix were 17 GPa and 10 GPa, respectively.Keywords
Funding Information
- Korea Institute of Industrial Technology (EH-21-0003)
This publication has 36 references indexed in Scilit:
- Effect of laser irradiation on failure mechanism of TiCp reinforced titanium composite coating produced by laser claddingJournal of Materials Processing Technology, 2014
- Effect of Fluid Convection on Dendrite Arm Spacing in Laser DepositionMetallurgical and Materials Transactions B, 2014
- Numerical simulation of molten pool dynamics in high power disk laser weldingJournal of Materials Processing Technology, 2012
- The influence of combined laser parameters on in-situ formed TiC morphology during laser claddingSurface and Coatings Technology, 2011
- Effect of pulsed laser parameters on in-situ TiC synthesis in laser surface treatmentOptics and Lasers in Engineering, 2011
- Decomposition in multi-component AlCoCrCuFeNi high-entropy alloyActa Materialia, 2011
- Effect of laser cladding process parameters on clad quality and in-situ formed microstructure of Fe–TiC composite coatingsSurface and Coatings Technology, 2010
- Nanostructured High‐Entropy Alloys with Multiple Principal Elements: Novel Alloy Design Concepts and OutcomesAdvanced Engineering Materials, 2004
- Relationships between hardness, Young's modulus and elastic recovery in hard nanocomposite coatingsSurface and Coatings Technology, 2002
- On the significance of the H/E ratio in wear control: a nanocomposite coating approach to optimised tribological behaviourWear, 2000