Form‐Factor Free 3D Copper Circuits by Surface‐Conformal Direct Printing and Laser Writing
- 9 September 2020
- journal article
- research article
- Published by Wiley in Advanced Functional Materials
- Vol. 30 (45)
Abstract
Recently, the fabrication of 3D circuits has attracted significant attention in the context of the realization of a new‐generation of printed electronics. In particular, form‐factor free Cu conductors have been recognized as the key to a constituent layer that can interconnect on demand a variety of active/passive components on arbitrarily designable platforms. However, even with their characteristic advantages of cost‐effectiveness and high electrical conductivity, 3D printed Cu circuits have been not suggested, owing to the difficulty of suppressing undesirable oxidation reactions and the absence of appropriate strategies for transforming the 3D particulate layers into device‐quality conductive ones. In this study, multidimensional particles are proposed that allow for deep penetration of incident photons in the surface‐conformal laser writing process, mechanisms of which are fully clarified based on an optical simulation‐based physical interpretation. The critical factors determining the electrical properties are elucidated through a spectroscopy‐based investigation for 3D structured Cu conductors. It is demonstrated that 16.5 µm thick Cu features (with values of resistivity and resistance of 15 µΩ cm and 0.91 Ω cm−1, respectively) can be created simply by successive 3D printing and laser writing processes, facilitating a user‐friendly design of low‐cost, high performance, form‐factor free electrical circuits.Keywords
Funding Information
- National Research Foundation of Korea
- Korea Research Institute of Chemical Technology (SS2021‐10)
This publication has 49 references indexed in Scilit:
- 3D Printing of Reduced Graphene Oxide NanowiresAdvanced Materials, 2014
- Light scattering and surface plasmons on small spherical particlesLight: Science & Applications, 2014
- 3D Printing for the Rapid Prototyping of Structural ElectronicsIEEE Access, 2014
- One-Step Fabrication of Copper Electrode by Laser-Induced Direct Local Reduction and Agglomeration of Copper Oxide NanoparticleThe Journal of Physical Chemistry C, 2011
- Effect of Carboxylic Acid on Sintering of Inkjet-Printed Copper Nanoparticulate FilmsACS Applied Materials & Interfaces, 2011
- Conformal Printing of Electrically Small Antennas on Three‐Dimensional SurfacesAdvanced Materials, 2011
- Omnidirectional Printing of Flexible, Stretchable, and Spanning Silver MicroelectrodesScience, 2009
- Controlling the Thickness of the Surface Oxide Layer on Cu Nanoparticles for the Fabrication of Conductive Structures by Ink‐Jet PrintingAdvanced Functional Materials, 2008
- Solvent and Ligand Effects on the Localized Surface Plasmon Resonance (LSPR) of Gold ColloidsThe Journal of Physical Chemistry B, 2004
- Optical Constants of the Noble MetalsPhysical Review B, 1972