Fabrication of porous alumina on quartz crystal microbalances
Authors:
- 15 May 2007
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 101 (10) , 104909
Abstract
Nanoporous alumina structures were fabricated on quartz crystal microbalances (QCMs) by electrochemically anodizing aluminum electrodes which had a typical thickness of . By varying the temperature and voltage of anodization, the diameter of the cylindrical pores could be controlled in the range of . Properties of the porous films were determined from scanning electron microscopy images and by analyzing isotherms of nitrogen, propane, and water. The isotherms showed signatures of capillary condensation and hysteresis. The mass sensitivity of the QCMs with porous alumina electrodes was increased by a factor of up to 120 compared to conventional QCMs with flat electrodes. Measurements at atmospheric pressure and room temperature in which the relative humidity was varied showed that QCMs with porous alumina electrodes are very sensitive to the partial pressure of water, and can be used as humidity sensors.
Keywords
This publication has 16 references indexed in Scilit:
- Superfluid transitions and capillary condensation in porous mediaPhysical Review B, 2006
- Simultaneous determination of density and viscosity of liquids based on quartz-crystal resonators covered with nanoporous aluminaJournal of Applied Physics, 2005
- Kosterlitz-Thouless Transition forFilms Adsorbed to Rough SurfacesPhysical Review Letters, 2004
- Alumina nanotemplate fabrication on silicon substrateNanotechnology, 2004
- Impedance Analysis and Single-Channel Recordings on Nano-Black Lipid Membranes Based on Porous AluminaBiophysical Journal, 2004
- Ultrasensitive quartz crystal microbalance with porous gold electrodesApplied Physics Letters, 2004
- Room Temperature Ammonia and Humidity Sensing Using Highly Ordered Nanoporous Alumina FilmsSensors, 2002
- Hexagonal pore arrays with a 50–420 nm interpore distance formed by self-organization in anodic aluminaJournal of Applied Physics, 1998
- Verwendung von Schwingquarzen zur W gung d nner Schichten und zur Mikrow gungThe European Physical Journal A, 1959
- Structural Features of Oxide Coatings on AluminumJournal of the Electrochemical Society, 1953