In vitro study of heat production during power reduction of equine mandibular teeth
Authors:
- Gordon J. BakerGBGordon J. Baker
- David E. FreemanDFDavid E. Freeman
- Kenneth R. HolmesKHKenneth R. Holmes
- Sandra Manfra MarrettaSMSandra Manfra Marretta
- R. Dean ScogginsRSR. Dean Scoggins
- Peter ConstablePCPeter Constable
- 1 April 2004
- journal article
- Published by American Veterinary Medical Association (AVMA) in Journal of the American Veterinary Medical Association
- Vol. 224 (7) , 1128-1132
Abstract
Objective—To measure the amount of heat generated during 3 methods of equine dental reduction with power instruments. Design—In vitro study. Sample Population—30 premolar and molar teeth removed from mandibles of 8 equine heads collected at an abbatoir. Procedure—38-gauge copper-constantan thermocouples were inserted into the lingual side of each tooth 15 mm (proximal) and 25 mm (distal) from the occlusal surface, at a depth of 5 mm, which placed the tip close to the pulp chamber. Group-NC1 (n = 10) teeth were ground for 1 minute without coolant, group-NC2 (10) teeth were ground for 2 minutes without coolant, and group-C2 (10) teeth were ground for 2 minutes with water for coolant. Results—Mean temperature increase was 1.2°C at the distal thermocouple and 6.6°C at the proximal thermocouple for group-NC1 teeth, 4.1°C at the distal thermocouple and 24.3°C at the proximal thermocouple for group-NC2 teeth, and 0.8°C at the distal thermocouple and –0.1°C at the proximal thermocouple for group-C2 teeth. Conclusions and Clinical Relevance—In general, an increase of 5°C in human teeth is considered the maximum increase before there is permanent damage to tooth pulp. In group-NC2 teeth, temperature increased above this limit by several degrees, whereas in group-C2 teeth, there was little or no temperature increase. Our results suggest that major reduction of equine teeth by use of power instruments causes thermal changes that may cause irreversible pulp damage unless water cooling is used. (J Am Vet Med Assoc 2004;224:1128–1132)Keywords
This publication has 12 references indexed in Scilit:
- Equine dental disease Part 2: a long‐term study of 400 cases: disorders of development and eruption and variations in position of the cheek teethEquine Veterinary Journal, 1999
- Equine dental disease Part 1: A long‐term study of 400 cases: disorders of incisor, canine and first premolar teethEquine Veterinary Journal, 1999
- Dentinal temperature transients caused by exposure to CO2 laser irradiation and possible pulpal damageJournal of Dentistry, 1990
- Management of the inflamed pulp associated with deep carious lesionJournal of Endodontics, 1981
- Heat Transfer in TeethJournal of Dental Research, 1973
- Effect of temperature changes on intrapulpal pressure and hydraulic permeability in dogsArchives of Oral Biology, 1969
- The fine structure of the mouse odontoblastArchives of Oral Biology, 1968
- The Ultrastructure of Odontorlasts in Perfusion Fixed, Demineralised Incisors of Adult RatsActa Odontologica Scandinavica, 1966
- Pulp response to externally applied heatOral Surgery, Oral Medicine, Oral Pathology, 1965
- Microscopic Observations on Living Dental Pulp II. The Effect of Thermal Irritants on the Circulation of the Pulp in the Lower Rat IncisorActa Odontologica Scandinavica, 1958