Characteristics of abrasive slurry jet micro-machining: A comparison with abrasive air jet micro-machining
Authors:
- H. NouraeiHNH. Nouraei
- A. WodoslawskyAWA. Wodoslawsky
- M. PapiniMPM. Papini
- J.K. SpeltJSJ.K. Spelt
- 1 October 2013
- journal article
- Published by Elsevier in Journal of Materials Processing Technology
- Vol. 213 (10) , 1711-1724
Abstract
No abstract availableFunding Information
- Natural Sciences and Engineering Research Council of Canada
- Micralyne Inc.
- BIC Fuel Cells Inc
This publication has 45 references indexed in Scilit:
- Laser shadowgraphy measurements of abrasive particle spatial, size and velocity distributions through micro-masks used in abrasive jet micro-machiningJournal of Materials Processing Technology, 2012
- Flow Dynamic Simulation of Micro Abrasive Water JetSolid State Phenomena, 2011
- Measurement of the particle spatial and velocity distributions in micro-abrasive jetsMeasurement Science and Technology, 2011
- Modeling the Material Removal Rate in Micro Abrasive Water Jet Machining of GlassesAdvanced Materials Research, 2010
- A study on the micro tooling for micro/nano millingThe International Journal of Advanced Manufacturing Technology, 2010
- Abrasive water-jet controlled depth milling of Ti6Al4V alloy – an investigation of the role of jet–workpiece traverse speed and abrasive grit size on the characteristics of the milled materialJournal of Materials Processing Technology, 2005
- The introduction of powder blasting for sensor and microsystem applicationsSensors and Actuators A: Physical, 2000
- The erosion of four materials using seven erodents — towards an understandingWear, 1999
- Effect of nozzle geometry and semi-confinement on the potential core of a turbulent axisymmetric free jetInternational Communications in Heat and Mass Transfer, 1996
- The influence of the flow field in slurry erosionWear, 1992