30 μm Thin Anode Gas Diffusion Layers for Optimized PEM Fuel Cell Operation at 120 °C and Low Relative Humidity
Open Access
- 8 December 2023
- journal article
- research article
- Published by Wiley in Advanced Energy and Sustainability Research
- Vol. 5 (2)
Abstract
Achieving higher temperature operation above 100 °C, while increasing the volumetric power density are key targets in current fuel cell development. In this work, a novel type of polyvinylidene fluoride and graphite based microporous film of only 30 μm thickness, acting as thin alternative to typical gas diffusion layers (GDLs) on the anode side of a hydrogen fuel cell is reported. Ex situ measurements (contact angle, electric conductivity, gas permeability measurements, and scanning electron microscopy (SEM)) reveal that the thin, porous layers achieve comparable chemical, electrical, and transport properties to commonly employed and significantly thicker gas diffusion layers. In‐situ fuel cell tests reveal considerable improvements, particularly in the target operation range beyond 100 °C: At 120 °C and 30% RH and 0.65 V cell voltage, the best thin anode layer enables a 51% higher current density (1342 vs 885 mA cm−2) and a 9% lower high frequency resistance (76 vs 84 mΩ cm−2) compared to a commercial state‐of‐the‐art GDL.Keywords
Funding Information
- Bundesministerium für Forschung, Technologie und Raumfahrt (03SF0719C)
This publication has 31 references indexed in Scilit:
- Hydrophilic and hydrophobic double microporous layer coated gas diffusion layer for enhancing performance of polymer electrolyte fuel cells under no-humidification at the cathodeJournal of Power Sources, 2012
- Gas diffusion layer for proton exchange membrane fuel cells—A reviewJournal of Power Sources, 2009
- Fabrication of GDL microporous layer using PVDF for PEMFCsJournal of Physics: Conference Series, 2009
- Effect of preparative parameters on the characteristic of poly(vinylidene fluoride)-based microporous layer for proton exchange membrane fuel cellsJournal of Power Sources, 2008
- PEM fuel cell relative humidity (RH) and its effect on performance at high temperaturesElectrochimica Acta, 2008
- Rough ideas on wettingPhysica A: Statistical Mechanics and its Applications, 2002
- Operating Proton Exchange Membrane Fuel Cells Without External Humidification of the Reactant Gases: Fundamental AspectsJournal of the Electrochemical Society, 1997
- Effect of spreading pressure on surface free energy determinations by means of contact angle measurementsJournal of Colloid and Interface Science, 1983
- Calculation of interfacial tension in polymer systemsJournal of Polymer Science Part C: Polymer Symposia, 1971
- On contact angle and dispersion energy of the cleavage graphite/water systemJournal of Colloid and Interface Science, 1970