On the Springback and Load in Three-Point Air Bending of the AW-2024 Aluminium Alloy Sheet with AW-1050A Aluminium Cladding
Open Access
Abstract
This article presents the results of an analysis of the bending load characteristics and the springback phenomenon occurring during three-point bending of 1.0 and 2.0 mm thick AW-2024 aluminium alloy sheets with rolled AW-1050A cladding. A new proprietary equation was proposed for determining the bending angle as a function of deflection, which takes into account the influence of the tool radius and the sheet thickness. The experimentally determined springback and bending load characteristics were compared with the results of numerical modelling using different models: Model I, a 2D model for a plane deformation state, disregarding the material properties of the clad layers; Model II, a 2D model for a plane deformation state, taking into account the material properties of the cladding layers; Model III, a 3D shell model with the Huber–von Mises isotropic plasticity condition; Model IV, a 3D shell model with the Hill anisotropic plasticity condition; and Model V, a 3D shell model with the Barlat anisotropic plasticity condition. The effectiveness of these five tested FEM models in predicting the bending load and springback characteristics was demonstrated. Model II was the most effective in predicting bending load, while Model III was the most effective in predicting the amount of springback after bending.Keywords
This publication has 20 references indexed in Scilit:
- Comparison of Quasi-Static Constitutive Equations and Modeling of Flow Curves for Austenitic 304 and Ferritic 430 Stainless SteelsActa Physica Polonica A, 2017
- Springback Prediction of High-strength Steels in Large Radius Air Bending Using Finite Element Modeling ApproachProcedia Engineering, 2014
- Effect of heat treatment on the bending behavior of tri-layered Cu/Al/Cu composite platesMaterials & Design (1980-2015), 2013
- Development and application of the material constitutive model in springback prediction of cold-bendingMaterials & Design (1980-2015), 2012
- Tolerable corrosion damage on aircraft aluminum structures: Local cladding patternsTheoretical and Applied Fracture Mechanics, 2012
- Air bending and springback of stainless steel clad aluminum sheetJournal of Materials Processing Technology, 2010
- A technical note on an experimental device to measure friction coefficient in sheet metal formingJournal of Materials Processing Technology, 2006
- Description of the flow behaviour of a high strength austenitic steel under biaxial loading by a constitutive equationNuclear Engineering and Design, 1991
- A six-component yield function for anisotropic materialsInternational Journal of Plasticity, 1991
- Plastic instability under plane stressJournal of the Mechanics and Physics of Solids, 1952