Bosch deep silicon etching: improving uniformity and etch rate for advanced MEMS applications
Authors:
- A. SchilpASA. Schilp
- K. FunkKFK. Funk
- M. OffenbergMOM. Offenberg
- 1 January 1999
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10846999,p. 211-216
Abstract
Bosch deep silicon etching is nowadays widely used on inductive coupled plasma equipment. Most inductive plasma sources in the field consist of a coil of one or several turns wound around a dielectric vessel, which is powered by radio frequency to generate a high density plasma. Wafers are placed onto a substrate electrode downstream of the plasma source. RF self-biasing is applied to accelerate ions from the high density plasma towards the wafer. A major drawback of this kind of plasma source is its limited uniformity, which lowers the yield in critical MEMS applications. In this paper, we present an approach to improve etch uniformity by introducing an aperture construction between the plasma source and the wafer. In combination with balanced coil drive, excellent uniformity over 150 mm diameter wafers was achieved even at very high etch-rates.Keywords
This publication has 6 references indexed in Scilit:
- High-etch-rate deep anisotropic plasma etching of silicon for MEMS fabrication1998
- Balanced Inductive Plasma SourcesJapanese Journal of Applied Physics, 1996
- Advanced silicon etching using high-density plasmas1995
- Low temperature etching of Si in high density plasma using SF6/O2Microelectronic Engineering, 1995
- Etching of Si with Cl2 using an electron cyclotron resonance sourceJournal of Vacuum Science & Technology A, 1993
- Deep trench plasma etching of single crystal silicon using SF6/O2 gas mixturesJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 1992