Hydrophilic nanofibrous composite membrane prepared by melt-blending extrusion for effective separation of oil/water emulsion
Authors:
Open Access
- 20 January 2017
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 7 (12) , 7108-7115
Abstract
A polyethylene-co-polyvinyl alcohol (EVOH) nanofiber membrane was prepared by the melt blending extrusion and high-speed airflow deposition process. Then nano cellulose crystal/polyethylene-co-polyvinyl alcohol (NCC/EVOH) nanofiber composite membranes were obtained via coating and depositing the barrier layer on the surface of the nanofiber membrane. The basic structural properties and oil–water separation performance of the composite membranes were investigated. The results show that the deposited NCC formed a dense layer in the surface of the nanofiber membrane with smaller pore size, and had no effect on the continuous pore structure of the membrane. With increasing NCC content, the composite membranes showed an increase of tensile strength (from 9.969 MPa to 12.991 MPa) and a decrease of contact angle, pore size, and water flux. The water flux and the filtration flux of the composite membrane can be improved within a certain range by increasing the operating pressure. The NCC/EVOH nanofiber composite membranes were successfully applied for the separation of oil–water emulsion and exhibited a higher rejection rate (99.5%). Moreover, the NCC/EVOH nanofiber composite membranes possessed a higher recovery rate of filtration flux than unmodified EVOH nanofiber membranes and the commercial micro-filtration membranes.Keywords
Funding Information
- National Natural Science Foundation of China (21374015)
This publication has 42 references indexed in Scilit:
- Structure and surface nanomechanics of poly(l-lactide) from thermally induced phase separation processApplied Surface Science, 2012
- Electrospun nanofibrous membranes for high flux microfiltrationJournal of Membrane Science, 2012
- Gelatin nanofibers fabricated by extruding immiscible polymer solution blend and their application in tissue engineeringJournal of Materials Chemistry, 2011
- Preparation of polyester nanofibers and nanofiber yarns from polyester/cellulose acetate butyrate immiscible polymer blendsJournal of Applied Polymer Science, 2011
- Preparation and characterization of CNTs/PE micro-nanofibersPolymers for Advanced Technologies, 2011
- Preparation, structure and crystallinity of chitosan nano-fibers by a solid–liquid phase separation techniqueCarbohydrate Polymers, 2011
- Water treatment technology for produced waterWater Science & Technology, 2010
- Experimental investigation of oily wastewater treatment using combined membrane systemsWater Science & Technology, 2010
- Performance of cellulose acetate – polyethersulphone blend membrane prepared using microwave heating for palm oil mill effluent treatmentWater Science & Technology, 2007
- Nanofiltration of textile wastewater for water reuseDesalination, 2002