Improving the Resolution of 3D-Printed Molds for Microfluidics by Iterative Casting-Shrinkage Cycles
- 7 February 2017
- journal article
- research article
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 89 (4) , 2227-2231
Abstract
Breaking through technical barriers and cost reduction are critical issues for the development of microfluidic devices, and both rely greatly on the innovation of fabrication techniques and use of new materials. The application of 3D printing definitely accelerated the prototyping of microfluidic chips by its versatility and functionality. However, the resolution of existing 3D printing techniques is still far below that of lithography, which makes it difficult to work on the scale of single cells and near impossible for single molecule work. In this paper, we present a facile way to increase the resolution of 3D printed microstructures to minimally 4 μm by casting-shrinkage cycles of a polyurethane (PU) polymer. A water–PU liquid mixture poured on a 3D printed template quickly solidifies replicating the structures, which then isometrically shrink to half its size after solvent evaporation, downscaling the replicated structures. By repeating the casting-shrinkage cycles, we could downscale the (sub)millimeter structures of 3D printed structures on demand, until the working limit posed by the polymer properties, which we demonstrate by fabricating a micromixer. Moreover, we can even fabricate microfluidic chips from millimeter-scale manually assembled templates, fully independent of any micromachining facilities, significantly reducing the technical barriers and costs, thus opening up the microfluidics field to low-resource areas.Keywords
Funding Information
- Ministry of Education of the People's Republic of China (3102015ZY059)
- National Natural Science Foundation of China (21602176)
This publication has 39 references indexed in Scilit:
- Quantification of ovarian cancer markers with integrated microfluidic concentration gradient and imaging nanohole surface plasmon resonanceThe Analyst, 2013
- Integrated 3D-printed reactionware for chemical synthesis and analysisNature Chemistry, 2012
- Better shrinkage than Shrinky-DinksLab on a Chip, 2010
- Soft lithography for micro- and nanoscale patterningNature Protocols, 2010
- Tunable Nanowrinkles on Shape Memory Polymer SheetsAdvanced Materials, 2009
- Plastic masters—rigid templates for soft lithographyLab on a Chip, 2009
- FLASH: A rapid method for prototyping paper-based microfluidic devicesLab on a Chip, 2008
- Shrinky-Dink microfluidics: 3D polystyrene chipsLab on a Chip, 2008
- Shrinky-Dink microfluidics: rapid generation of deep and rounded patternsLab on a Chip, 2007
- Combined microfluidic-micromagnetic separation of living cells in continuous flowBiomedical Microdevices, 2006