Case study on the effectiveness of gear fault diagnosis technique for gear tooth defects under fluctuating speed
Authors:
Open Access
- 15 September 2017
- journal article
- case study
- Published by Institution of Engineering and Technology (IET) in IET Renewable Power Generation
- Vol. 11 (14) , 1841-1849
Abstract
Gears are very reliable parts of wind turbines and normally contribute for more than 5 years without failure when operated under fluctuating speed conditions. This case study presents the effectiveness of gear fault diagnosis techniques to highlight cracked tooth, chipped tooth and missing tooth gear under fluctuating speed conditions. Various measuring parameters such as overall vibration acceleration and envelope‐detected acceleration were calculated for vibration signal, and sound intensity and sound pressure were calculated for acoustic signal. A statistical indicator kurtosis was also calculated for both vibration signal and acoustic signal. These measuring parameters were then compared with showing the fault detection capability of techniques employed under fluctuating speed and also under different loading conditions. The detection of faults by kurtosis of acoustic signal is found most efficient. For low load conditions, envelope‐detected acceleration of vibration signal can also support fault diagnosis under fluctuating speed conditions.Keywords
This publication has 20 references indexed in Scilit:
- A Review of Gear Fault Diagnosis Using Various Condition IndicatorsProcedia Engineering, 2016
- Automatic gear and bearing fault localization using vibration and acoustic signalsApplied Acoustics, 2015
- Failure analysis of air cooled condenser gearboxCase Studies in Engineering Failure Analysis, 2014
- Condition monitoring of a single-stage gearbox with artificially induced gear cracks utilizing on-line vibration and acoustic emission measurementsApplied Acoustics, 2009
- Dynamic modelling of spur gear pair and application of empirical mode decomposition-based statistical analysis for early detection of localized tooth defectJournal of Sound and Vibration, 2006
- Use of the acceleration signal of a gearbox in order to perform angular resampling (with limited speed fluctuation)Mechanical Systems and Signal Processing, 2005
- A review of vibration-based techniques for helicopter transmission diagnosticsJournal of Sound and Vibration, 2005
- DETECTION OF GEAR FAILURES VIA VIBRATION AND ACOUSTIC SIGNALS USING WAVELET TRANSFORMMechanical Systems and Signal Processing, 2003
- A COMPARATIVE STUDY OF ACOUSTIC AND VIBRATION SIGNALS IN DETECTION OF GEAR FAILURES USING WIGNER–VILLE DISTRIBUTIONMechanical Systems and Signal Processing, 2001
- A review of vibration and acoustic measurement methods for the detection of defects in rolling element bearingsTribology International, 1999