A Reproducible Benchmarking Framework for Differential Evolution Variants in Wind Turbine Controller Tuning
Open Access
- 18 September 2026
- Vol. 19 (18) , 4420
Abstract
Modern wind turbines require effective control strategies to maximize energy capture under partial-load conditions while maintaining generator-speed and power regulation above the rated wind speed. This study proposes and applies a controlled and reproducible benchmarking framework for evaluating classical Differential Evolution (DE) variants in the tuning of Proportional–Integral–Derivative (PID) and Proportional–Integral–Derivative–Accelerative (PIDA) controllers for a nonlinear model of the National Renewable Energy Laboratory 5-MW reference wind turbine. Twenty classical DE variants were assessed using a fixed-seed initialization strategy, unified simulation procedures, consistent objective-function definitions, and region-specific optimization settings applied uniformly to all variants within each operating region. The controllers were evaluated in Region 2, where maximum power point tracking is required, and Region 3, where generator speed and electrical power must be regulated under above-rated wind conditions. Their generalization performance was subsequently evaluated in simulation using a measured wind-speed profile obtained from a Supervisory Control and Data Acquisition system. In Region 2, under the considered fixed-seed configuration, the DE-tuned controller achieving the lowest objective-function value reduced the objective function by approximately 2.93% compared with the baseline PID controller, indicating a moderate improvement. In Region 3, the PIDA controller tuned with the DE variant yielding the lowest objective-function value achieved a reduction of up to 92% relative to the baseline controller, demonstrating a substantially greater benefit under above-rated operation. However, validation using the measured wind profile indicated that some controllers with favorable tuning-stage results showed signs of overfitting and reduced generalization performance. Overall, the results indicate that the suitability of the controller structure and DE configuration depends on the wind turbine operating region and highlight the importance of controlled, reproducible optimization procedures and validation beyond the tuning scenario in wind turbine controller design.Keywords
All Related Versions
Funding Information
- Universidad Politécnica Salesiana del Ecuador (002-001-2026-02-02)
This publication has 35 references indexed in Scilit:
- Generalized Haalman tuning of PIDA controllersIFAC-PapersOnLine, 2024
- A review on power control of wind turbines with the perspective of dynamic load mitigationOcean Engineering, 2024
- Attitude control of a quadrotor using PID controller based on differential evolution algorithmExpert Systems with Applications, 2023
- Comparative Performance Analysis of Differential Evolution Variants on Engineering Design ProblemsJournal of Bionic Engineering, 2022
- Trajectory control of electro-hydraulic position servo system using improved PSO-PID controllerAutomation in Construction, 2021
- Study of Hopf curves in the time delayed active control of a 2DOF nonlinear dynamical systemSN Applied Sciences, 2020
- Whale optimization algorithm to tune PID and PIDA controllers on AVR systemAin Shams Engineering Journal, 2019
- Robust tuned PID controller with PSO based on two-point kinetic model and adaptive disturbance rejection for a PWR-type reactorProgress in Nuclear Energy, 2019
- Improvement of positive position feedback controller for suppressing compressor blade oscillationsNonlinear Dynamics, 2017
- Research on power coefficient of wind turbines based on SCADA dataRenewable Energy, 2016