A Scalable Power Splitter using High Sheet Polysilicon Resistor Suitable for RFIC Application
Authors:
- 3 December 2022
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Abstract
Integrated circuits employing CMOS RF technology are increasingly common and widely deployed. There are currently a wide range of materials available for use in the process that are optimised for RF noise, matching characteristics, and improved resistivity. In this paper, the highly resistive passive resistor component is used in the power splitter circuits, where a high sheet polysilicon resistor is the best choice. The high sheet polysilicon resistor and its extracted parasitic capacitance are shown to be the best match among the various resistors mentioned in the literature. Power splitter circuits use these resistor characteristics to get the best possible results, such as low return and insertion losses and good isolation. In order to get the desired resistor values for the power splitter’s individual components, twelve parallel high sheet poly resistors are employed. A total of six electronic componentsâtwo metal finger capacitors and four lumped element spiral inductorsâare employed. Power splitter and probe pad components from the layout are on display. The correctness of the layout is confirmed by simulations run before to and after layout. The design schematic, pre-layout and post layout simulation results confirms that high sheet polysilicon resistors are the best selected potential candidate for RFIC application.Keywords
This publication has 16 references indexed in Scilit:
- CMOS-compatible on-chip self-rolled-up inductors for RF/mm-wave applications2017
- Constitutive parameter analysis of left‐handed dual‐star split‐ring resonator metamaterial for homogeneous infinite slabIET Microwaves, Antennas & Propagation, 2015
- Quality-Aware Streaming and Scheduling for Device-to-Device Video DeliveryIEEE/ACM Transactions on Networking, 2015
- Tunable linear MOS resistor for RF applications2012
- High-/Mixed-Voltage RF and Analog CMOS Circuits Come of AgeIEEE Circuits and Systems Magazine, 2010
- Low-Frequency Noise in Integrated N-WELL ResistorsIEEE Electron Device Letters, 2010
- Development of power control module in RFID reader circuit: A Mentor Graphic simulation approach2008
- Enhancing performance in interpolating resistor string DACs2003
- Mismatch and flicker noise characterization of tantalum nitride thin film resistors for wireless applications2002
- High-performance fully-depleted SOI RF CMOSIEEE Electron Device Letters, 2002