Changes of Surface Topography during Wear for Surfaces with Different Height Distributions
Authors:
- 1 January 2000
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 43 (4) , 749-757
Abstract
Surface topography is one of the leading factors affecting wear processes. This study investigated topographical changes of mechanical components with non-Gaussian surfaces under sliding wear. The Johnson translatory system of distributions was applied to describe different surface height distributions. A wear model that has been experimentally confirmed for sliding wear was used to describe changes of surface heights. Based on different wear particle size distributions generated during wear, variations of surface height distribution were investigated. Relationships between topographical change and original surfaces were established. Finally, the results predicted were compared with the results using a truncation wear modelKeywords
This publication has 17 references indexed in Scilit:
- Two-body microcutting wear model part II: Three-dimensional roughness modelWear, 1989
- Two-body microcutting wear model part I: Two-dimensional roughness modelWear, 1989
- Fundamental aspects of abrasive wear studied by a new numerical simulation modelWear, 1988
- Correlation between groove size, wear rate and topography of abraded surfacesWear, 1987
- Measurement of Local Microscopic WearJournal of Tribology, 1986
- Microgeometry of sliding surfaces and wear particles in lubricated contactWear, 1984
- The Pearson System of Distributions: Its Application to Non-Gaussian Surface Metrology and a Simple Wear ModelJournal of Lubrication Technology, 1980
- The evolution of asperity height distributions of a surface subjected to wearWear, 1976
- Wear of some F.C.C. metals during unlubricated sliding part II: effects of normal load, sliding velocity and atmospheric pressure on wear fragmentsWear, 1975
- Computer simulation of wearWear, 1972