Frictionally Excited Thermoelastic Instability in Multi-Disk Clutches and Brakes
- 7 December 2000
- journal article
- Published by ASME International in Journal of Tribology
- Vol. 123 (4) , 865-871
Abstract
The propensity toward thermoelastic instability (TEI) in multi-disk clutches and brakes is investigated by introducing a new bidimensional analytical model, where metal and friction disks are replaced by two-dimensional layers of finite thickness. This new model permits to estimate the effect of the thickness ratio a1/a2, between friction and metal disks, on the critical speed, critical wave parameter and migration speed of the sliding system. It is found that as the thickness ratio a1/a2 decreases the critical speed reduces significantly taking up values about 80 percent smaller than that predicted by previous two-dimensional models for commonly used ratios 0.1<a1/a2<1, whilst the critical wave parameter slightly increases. Therefore, not only the susceptibility towards TEI can be reduced by changing the material properties of the friction lining but also by adjusting suitably the thickness ratio of the disks. The two-dimensional model is also employed to determine the critical speed in a real multi-disk clutch, and the results are compared with a three-dimensional finite element code. It is shown that the critical speed estimated by the present two-dimensional plane strain model is in good agreement with that determined by the FE code for sufficiently large radial thickness of the disks, whilst the two-dimensional plane stress solution has to be used for relatively small radial thickness ratios. Also, it is found that the critical number of hot spots is independent of the radial thickness ratio and it is correctly predicted by the two-dimensional model.Keywords
This publication has 10 references indexed in Scilit:
- Eigenvalue solution of thermoelastic instability problems using Fourier reductionProceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2000
- Theoretical and Experimental Studies on the Thermal Degradation of Wet Friction MaterialsSAE International Journal of Advances and Current Practices in Mobility, 1997
- Friction Materials—Black Art or Science?Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 1995
- Frictionally Excited Thermoelastic Instability in Automotive Disk BrakesJournal of Tribology, 1993
- Thermal and Mechanical Damage of Paper Wet Friction Material Induced by Non-Uniform ContactSAE International Journal of Advances and Current Practices in Mobility, 1992
- Analysis of thermomechanical phenomena in multidisc clutches and brakesWear, 1990
- Hot spotting in automotive friction systemsWear, 1990
- Thermoelastic instability in a seal-like configurationWear, 1973
- Theoretical ElasticityPhysics Today, 1970
- Thermoelastic instabilities in the sliding of conforming solidsProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1969