High‐Performance Multilayer Capacitor Dielectrics from Chemically Prepared Powders
Authors:
- 1 May 1993
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 76 (5) , 1233-1241
Abstract
Advantages of chemically prepared powders for electronic ceramics have been demonstrated for a number of multilayer capacitor (MLC) dielectrics. A cost‐efficient precipitation process was developed to produce undoped or doped crystalline barium titanate powder with a narrow particle size distribution close to 0.5 μm. More complex compositions, e.g., barium‐neodymium titanate, were amorphous as precipitated but could be crystallized by calcination below 1000°C. Additional compositional modifications, to adjust electrical properties or to lower sintering temperature, were accomplished by doping the surface of the powder particles using a solution coating process. Exceptional fired densities and electrical performance were obtained.Keywords
This publication has 8 references indexed in Scilit:
- Influence of Core‐Shell Grains on the Internal Stress State and Permittivity Response of Zirconia‐Modified Barium TitanateJournal of the American Ceramic Society, 1990
- Alkoxide‐Hydroxide Route to Syntheltize BaTiO 3 ‐Based PowdersJournal of the American Ceramic Society, 1990
- Low-temperature synthesis and processing of electronic materials in the BaO-TiO2 systemJournal of Materials Science, 1990
- New high-performance, low-fire MLC dielectrics for SMT applicationsFerroelectrics, 1990
- Characterization of a new dielectric ceramic material for a smaller Y-5V MLCFerroelectrics, 1990
- The Curie point temperature of Ba(Ti1?x Zr x )O3 solid solutionsJournal of Materials Science, 1988
- Matrix Phase in Ceramics with Composition near BaO·Nd 2 O 3 ·5TiO 2Journal of the American Ceramic Society, 1986
- Ultrafine electroceramic powder preparation from metal alkoxidesFerroelectrics, 1983