Microstructure and Properties of Atmospheric Plasma Sprayed (Al,Cr)2O3–TiO2 Coatings from Blends
Authors:
Open Access
- 30 November 2021
- journal article
- research article
- Published by Springer Nature in Journal of Thermal Spray Technology
- Vol. 31 (1-2) , 256-268
Abstract
Coatings prepared from chromia-rich (Al,Cr)2O3solid solution (ss) feedstock powders are intended to improve the properties of Cr2O3coatings, but are rarely studied so far. In this work, the processability of a commercial (Al,Cr)2O3solid solution (ss) powder containing 78 wt.% Cr2O3by atmospheric plasma spraying (APS), the corresponding coating microstructures and properties were investigated. Possible further improvements were expected by blending with 2, 23 and 54 wt.% TiOxpowder. For comparison, plain Cr2O3and TiOxcoatings were studied as well. The microstructures were analyzed using SEM, EDS and XRD measurements. Hardness (HV0.3) was measured, as well as the dry unidirectional sliding wear resistance and the abrasion wear resistance (ASTM G65). Moreover, the corrosion and electrical insulating properties were measured. The (Al,Cr)2O3ss showed only a small change of the composition, and the formation ofγ-Al2O3, as found for alumina-rich (Al,Cr)2O3ss powders, was avoided. Compared to the plain chromia coating, some improvements of the processability and coating properties for the ss (Al,Cr)2O3coating were found. The most balanced coating performance was achieved by blending the ss (Al,Cr)2O3with 2 wt.% TiOx, as this coating showed both a high sliding and abrasion wear resistance, in combination with a high corrosion resistance.Keywords
Funding Information
- Technische Universität Chemnitz
This publication has 34 references indexed in Scilit:
- Sliding Wear Performance of Plasma-Sprayed Al2O3-Cr2O3 Composite Coatings Against Graphite under Severe ConditionsJournal of Thermal Spray Technology, 2013
- Microstructure and mechanical properties of Al2O3–Cr2O3 composite coatings produced by atmospheric plasma sprayingSurface and Coatings Technology, 2011
- Electronic structure of theMagnéli phasePhysical Review B, 2009
- Thermochemical Analysis and Modeling of the Al 2 O 3 –Cr 2 O 3 , Cr 2 O 3 –SiO 2 , and Al 2 O 3 –Cr 2 O 3 –SiO 2 Systems Relevant to RefractoriesJournal of the American Ceramic Society, 2005
- Fundamental parameters line profile fitting in laboratory diffractometersJournal of Research of the National Institute of Standards and Technology, 2004
- Improvement of the corrosion resistance of alumina–chromia ceramic materials in molten slagJournal of the European Ceramic Society, 2003
- Sintering behavior of Cr2O3–Al2O3 ceramicsJournal of the European Ceramic Society, 2000
- Electrical conductivity and defect structure of Cr2O3. I. High temperatures (>∼1000°C)Solid State Ionics, 1994
- Unit-cell refinement from powder diffraction scansJournal of Applied Crystallography, 1981
- Hard material powders and hard alloy powders for plasma surface coatingThin Solid Films, 1980