Modeling and autotuning of AVP control with inductor DCR current sensing
Authors:
- 1 March 2014
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10482334,p. 1066-1072
Abstract
A new equivalent circuit model is presented to predict the small-signal characteristic of current-mode control with DCR current sensing accurately, and a simple auto-tuning method is proposed to solve the issue of time constant mismatch in DCR current sensing. The model shows that the mismatch between the current sensing RC network and the output inductor makes the output impedance deviate away from desired load-line resistance, so the transient response impairs. Adding more output capacitors can avoid transient spike, but increase component cost. Prior autotuning method solves mismatch issue by adjusting the time constant of RC network close to another such that output capacitors can be reduced, but the implementation is too complex for monolithically integration. Therefore, this paper develops a simple pole-zero compensation technique to maintain constant output impedance and fast transient under possible mismatch conditions, so output capacitor can be minimized with simpler autotuning circuit on VR controller. The SIMPLIS simulation with state-of-art output filter model of laptop VR and the experiment result on a commercial VR12 controller confirms the effectiveness of the proposed autotuning method.Keywords
This publication has 6 references indexed in Scilit:
- Unified Three-Terminal Switch Model for Current Mode ControlsIEEE Transactions on Power Electronics, 2012
- Modeling of digitally controlled voltage regulator modules2010
- Digital Autotuning System for Inductor Current Sensing in Voltage Regulation Module ApplicationsIEEE Transactions on Power Electronics, 2008
- Design Considerations for Small Signal Modeling of DC-DC Converters Using Inductor DCR Current Sensing Under Time Constants Mismatch Conditions2007
- Optimal design of the active droop control method for the transient response2004
- Design considerations for VRM transient response based on the output impedanceIEEE Transactions on Power Electronics, 2003