Liquid jet‐array cooling modules for high heat fluxes
- 16 April 1998
- journal article
- fluid mechanics-and-transport-phenomena
- Published by Wiley in AIChE Journal
- Vol. 44 (4) , 769-779
Abstract
Liquid jet‐array cooling modules had been designed for operation at very high heat fluxes and were used to remove fluxes as high as 17 MW/m2. Experimental results, numerical studies, and thermal stress analyses are reported. Modules having actively cooled areas of 10 cm2 were developed. Cooling is provided by an away of small‐diameter water jets operating at speeds of 47 m/s. These jets impinge on the rear side of a 2‐to 4‐mm‐thick metallic faceplate from which the heat load is absorbed. Cooling is entirely convective without boiling. The behavior of cooling jet arrays is summarized, including numerical simulations for our specific cases. Finite‐element studies of the stresses in candidate faceplate materials are described for typical thermal and mechanical conditions. A thin‐film high‐flax resistance heater provides the heat load for testing module prototypes. The thermal resistances of the system are quantified experimentally and incorporated in our numerical model. The dominant thermal resistance is associated with the heating element. The modules are believed to be serviceable to fluxes above 20 MW/m2, although dificulties with the heating element prevented this level from being reached.Keywords
This publication has 19 references indexed in Scilit:
- Yield Limits of Plates at Extremely High Heat FluxJournal of Heat Transfer, 1998
- Experiments on jet array cooling modules for high heat flux removal1997
- Large-area jet-array cooling modules for high heat fluxes1996
- Impinging jet studies for turbulence model assessment—II. An examination of the performance of four turbulence modelsInternational Journal of Heat and Mass Transfer, 1993
- Impinging jet studies for turbulence model assessment—I. Flow-field experimentsInternational Journal of Heat and Mass Transfer, 1993
- Extremely High Heat Fluxes Beneath Impinging Liquid JetsJournal of Heat Transfer, 1993
- Stagnation-Point Heat Transfer During Impingement of Laminar Liquid Jets: Analysis Including Surface TensionJournal of Heat Transfer, 1993
- Convective Heat Transfer by Impingement of Circular Liquid JetsJournal of Heat Transfer, 1991
- Upper Limit of CHF in the Saturated Forced Convection Boiling on a Heated Disk with a Small Impinging JetJournal of Heat Transfer, 1979
- The numerical computation of turbulent flowsComputer Methods in Applied Mechanics and Engineering, 1974