Fabrication of Nanostructured Aluminum Sheets Using Four-Layer Accumulative Roll Bonding
Authors:
- 14 February 2014
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 29 (4) , 448-453
Abstract
In this paper, an extended accumulative roll bonding (ARB) technique, called the ‘Four-Layer Accumulative Roll Bonding (FL-ARB)’ technique, is presented for the first time. This technique has been employed to produce ultrafine-grained commercial pure aluminum sheets with success. After three FL-ARB passes, the grain size of pure aluminum was seen to reduce to 380 nm. The bonding strength of the sheets after rolling has also been discussed. Theoretical calculations showed that the bonding strength of sheets processed by the FL-ARB technique can be 2–2.2 times greater than that by the traditional ARB technique. The main advantages of the FL-ARB technique are (a) improvement of the interface bonding, with increasing deformation in each pass, (b) applicability of the technique at room temperature to process most metals, and (c) generation of the largest equivalent strain in the workpiece with the same number of passes, compared with other severe plastic deformation techniques.Keywords
Funding Information
- The lead author gratefully acknowledges the financial support from the Vice-Chancellor's Fellowship Grant and URC small grant at the University of Wollongong, and from the National Natural Science Foundation of China through Grant 51105071.
This publication has 25 references indexed in Scilit:
- Experimental and numerical investigation of Al properties fabricated by CGP processMaterials Science and Engineering: A, 2012
- Development of Nanostructured Armco-Fe by Equal Channel Angular Extrusion (ECAE)Materials and Manufacturing Processes, 2012
- On the mechanical properties and microstructure of commercially pure Al fabricated by semi-constrained groove pressingMaterials Science and Engineering: A, 2011
- Al–Mg–Cu based alloys and pure Al processed by high pressure torsion: The influence of alloying additions on strengtheningMaterials Science and Engineering: A, 2010
- Work-hardening stages of AA1070 and AA6060 after severe plastic deformationJournal of Materials Science, 2010
- Microstructural evolution in pure aluminum processed by high-pressure torsionMaterials Science and Engineering: A, 2009
- Microstructure Evolution in Pure Al Processed with Twist ExtrusionMATERIALS TRANSACTIONS, 2009
- Shear deformation and grain refinement in pure Al by asymmetric rollingTransactions of Nonferrous Metals Society of China, 2008
- Production of ultrafine grain sizes in aluminium sheets by severe plastic deformation using the technique of groove pressingScripta Materialia, 2005
- Novel ultra-high straining process for bulk materials—development of the accumulative roll-bonding (ARB) processActa Materialia, 1999