Measuring velocity distributions of viscous fluids using positron emission particle tracking (PEPT)
- 14 June 2004
- journal article
- research article
- Published by Wiley in AIChE Journal
- Vol. 50 (7) , 1606-1613
Abstract
Positron emission particle tracking (PEPT) can be used to trace the path of a radioactive particle within opaque fluids in pilot‐scale equipment; the method can track particles through several centimeters of metal. PEPT has been successfully used to follow isokinetic tracers in viscous fluids and thus to measure velocity distributions under both isothermal and nonisothermal conditions in pipe flow. The accuracy of the method decreased as the measured velocities increased; the faster the particle traveled, the less accurate its detection. For velocities of up to 0.5 m/s the accuracy of the method was acceptable. Agreement between experimentally measured and theoretical velocity distributions was very good, for a range of fluids and process conditions. As tracer particles are used, there were problems ensuring that all parts of the measurement volume were sampled. This is possible to overcome to an extent by adjusting particle size; 600‐μm tracers did not pass within 1 mm from the tube wall, whereas 240‐μm particles passed much closer to the boundaries of the flow. © 2004 American Institute of Chemical Engineers AIChE J, 50: 1606–1613, 2004Keywords
This publication has 16 references indexed in Scilit:
- Use of Positron‐Emission Particle Tracking (PEPT) Technique for Velocity Measurements in Model Food FluidsJournal of Food Science, 2003
- Using positron emission particle tracking (PEPT) to study nearly neutrally buoyant particles in high solid fraction pipe flowInternational Journal of Multiphase Flow, 2001
- Fluid trajectories in a stirred vessel of non-newtonian liquid using positron emission particle trackingChemical Engineering Science, 2000
- Local transitions in flow phenomena through packed beds identified by MRIAIChE Journal, 2000
- Measurement of three‐dimensional velocity field in the translational region of a co‐rotating twin‐screw extruderPolymer Engineering & Science, 1998
- A concentric cylinder Couette flow system for use in magnetic resonance imaging experimentsMeasurement Science and Technology, 1998
- Measurement of velocity profiles in reverse‐screw elements of a twin‐screw extruderAIChE Journal, 1997
- Particle velocity profiles for solid-liquid food flows in vertical pipes part I. Single particlesPowder Technology, 1997
- Visualization of flow patterns of cellulose fiber suspensions by NMR imagingAIChE Journal, 1994
- Modeling Heat Transfer to Non-Newtonian Fluids in a Double Tube Heat ExchangerTransactions of the ASAE, 1989