Medium/high temperature water gas shift reaction in a Pd–Ag membrane reactor: an experimental investigation
- 3 November 2011
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 2 (1) , 226-233
Abstract
In the hydrogen production cycle the syngas stream coming out from reformers or coal gasification plants contains a large percentage of H2 (ca. 50%) and CO (ca 45%). In fact, it is systematically upgraded by a water gas shift reaction (WGS) in order to convert the CO present and, at the same time, to produce further hydrogen. Water gas shift is an exothermic thermodynamics limited reaction and the presence of products like H2 further depletes the CO conversion achievable. In traditional applications this upgrading stage is usually performed in two reaction stages: firstly, the syngas stream is fed to a reactor operated in a high temperature range (300–400 °C) to exploit the advantages offered by a fast kinetics; then, the outlet stream of the first reactor is fed, after cooling, in a low temperature stage, for the benefit of the thermodynamics. This final stream is, thus, fed to a separation unit to recover the hydrogen from the rest of the gaseous stream. In this work the upgrading of a syngas stream is experimentally investigated in a Pd-based membrane reactor (MR) operated in the medium/high temperature range (340–375 °C). The advantages on the MR performance offered by fast kinetics and permeation rate have been analyzed as a function of the feed pressure (up to 1100 kPa), feed molar ratio, and gas hourly space velocity (GHSV). The values of these variables used in the experiments are closer to those used in the industrial applications. The MR performance, compared with the ones of a traditional reactor (TR) operated in the same conditions, was evaluated also in terms of volume index which evidences the lower catalyst volume required by an MR for achieving the same conversion of a TR. Owing to the fast kinetics and permeation rate, the limit due to the presence of product (i.e., H2) in the feed stream added to that imposed by the thermodynamics were successfully overcome with the MR operated in the high temperature range. A CO conversion significantly higher than the thermodynamics upper limit of a TR was achieved, also at high values of GHSV and less than 30% of the reaction volume of a TR was required for achieving a conversion equal to 90% of the traditional reactor equilibrium conversion.Keywords
This publication has 20 references indexed in Scilit:
- Pd-based membrane reactors for one-stage process of water gas shiftRSC Advances, 2011
- Experimental and modeling studies on the low-temperature water-gas shift reaction in a dense Pd–Ag packed-bed membrane reactorChemical Engineering Science, 2011
- Membrane reactors for fuel cell quality hydrogen through WGSR – Review of their status, challenges and opportunitiesInternational Journal of Hydrogen Energy, 2011
- Enhancing the production of hydrogen via water–gas shift reaction using Pd-based membrane reactorsInternational Journal of Hydrogen Energy, 2010
- Evaluation of the water gas shift reaction in a palladium membrane reactorCatalysis Today, 2010
- An innovative configuration of a Pd-based membrane reactor for the production of pure hydrogenJournal of Power Sources, 2008
- Comparison of environmental and economic aspects of various hydrogen production methodsRenewable and Sustainable Energy Reviews, 2008
- WGS reaction in a membrane reactor using a porous stainless steel supported silica membraneChemical Engineering and Processing - Process Intensification, 2007
- High‐temperature kinetics of the homogeneous reverse water–gas shift reactionAIChE Journal, 2004
- Equilibrium conversion for a Pd-based membrane reactor. Dependence on the temperature and pressureChemical Engineering and Processing - Process Intensification, 2003