An Integral Method to Determine Workpiece Flow Stress and Friction Characteristics in Metal Cutting
Authors:
- Norfariza WahabNWNorfariza Wahab
- Tokyo University of Agriculture and TechnologyTTTokyo University of Agriculture and Technology
- Yumi InatsuguYIYumi Inatsugu
- Satoshi KubotaSKSatoshi Kubota
- Soo-Young KimSKSoo-Young Kim
- Hiroyuki SasaharaHSHiroyuki Sasahara
- Ltd. Yamanaka Eng. Co.LCLtd. Yamanaka Eng. Co.
- 5 November 2015
- journal article
- Published by Fuji Technology Press Ltd. in International Journal of Automation Technology
- Vol. 9 (6) , 775-781
Abstract
In recent times, numerical simulation techniques have been commonly used to estimate and predict machining parameters such as cutting forces, stresses, and temperature distribution. However, it is very difficult to estimate the flow stress of a workpiece and the friction characteristics at a tool/chip interface, particularly during a high-speed cutting process. The objective of this study is to improve the accuracy of the present method and simultaneously determine the characteristics of the flow stress of a workpiece and friction at the cutting edge under a high strain rate and temperature during the cutting process. In this study, the Johnson-Cook (JC) flow stress model is used as a function of strain, strain rate, and temperature. The friction characteristic was estimated by minimizing the difference between the predicted and measured results of principal force, thrust force, and shear angle. The shear friction equation was used to estimate the friction characteristics. Therefore, by comparing the measured values of the cutting forces with the predicted results from FEM simulations, an expression for workpiece flow stress and friction characteristics at the cutting edge during a high-speed cutting process was estimated.Keywords
This publication has 12 references indexed in Scilit:
- Shear localization sensitivity analysis for Johnson–Cook constitutive parameters on serrated chips in high speed machining of Ti6Al4VSimulation Modelling Practice and Theory, 2015
- Strain, strain rate and velocity fields determination at very high cutting speedJournal of Materials Processing Technology, 2013
- MECHANISM OF CHIP FORMATION IN HIGH-SPEED TURNING OF INCONEL 718Machining Science and Technology, 2011
- SPH method applied to high speed cutting modellingInternational Journal of Mechanical Sciences, 2007
- Some Observations of the Chip Formation Process and the White Layer Formation in High Speed Milling of Hardened SteelMachining Science and Technology, 2004
- Determination of flow stress for metal cutting simulation—a progress reportJournal of Materials Processing Technology, 2004
- Investigation of surface integrity in high speed end milling of a low alloyed steelInternational Journal of Machine Tools and Manufacture, 2003
- Process modeling in machining. Part II: validation and applications of the determined flow stress dataInternational Journal of Machine Tools and Manufacture, 2001
- Process modeling in machining. Part I: determination of flow stress dataInternational Journal of Machine Tools and Manufacture, 2001
- Requirements on Tools and Machines When Machining Hard Materials1986