Graphene's effect and mechanism on the properties of alkali-activated slag coating
Open Access
- 1 June 2023
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 10 (6) , 065201
Abstract
Using alkali-activated slag to prepare coatings is an alternative solution for concrete repair and protection. However, shrinkage cracking limits the application of alkali-activated slag, which also increases the risk of coating peeling. Graphene dispersions (content of 0.2%, 0.4%, 0.6% and 0.8%) were added to the alkali-activated slag coatings. The drying time, apparent circumstance (thicknesses of 1 mm, 2 mm, 3 mm and 5 mm) and the tensile bond strength with 1 mm thickness coating were determined. The mechanism of action was analyzed in terms of both product and interfacial properties. The experimental results showed that the graphene dispersion would shorten the drying time of the coatings. The drying time was reduced by 57.1% (from 116 min to 52 min). Moreover, the graphene dispersion improves the cracking of the coating. The larger the coating thickness is, the better it improves the cracking effect. The surface cracking of the coating with 5 mm thickness was reduced by 60.7% (from 1.6751% to 0.6583%). Graphene can significantly improve the bond strength of the coating. When the graphene content is 0.8%, the bonding strength with a thickness of 1 mm is 0.502 MPa at 7 days and 1.577 MPa at 28 days. The bond strength increased by 280.3% and 175.2%, respectively, XRD, FTIR and SEM analysis showed that the increase in bond strength was caused by two factors. (1) Graphene can promote the generation of zeolite phase in alkali-activated slag. This is conducive to enhancing the interlayer adhesion of the coating itself. (2) Graphene is beneficial to reduce the pores in the transition zone between the coating and the substrate and enhance the contact area between the coating and the substrate and makes the transition zone denser.Keywords
This publication has 41 references indexed in Scilit:
- Evaluation of tensile bonding strength between UHTCC repair materials and concrete substrateConstruction and Building Materials, 2016
- Characterizing the bond strength of geopolymers at ambient and elevated temperaturesCement and Concrete Composites, 2015
- The effects of phase changes on the bonding property of geopolymer to hydrated cementConstruction and Building Materials, 2013
- Potential application of geopolymers as protection coatings for marine concrete III. Field experimentApplied Clay Science, 2012
- Evolution of binder structure in sodium silicate-activated slag-metakaolin blendsCement and Concrete Composites, 2011
- Comparison of FT-IR, Thermal Analysis and XRD for Determination of Products of Cement HydrationAdvanced Materials Research, 2010
- Potential application of geopolymers as protection coatings for marine concreteI. Basic propertiesApplied Clay Science, 2010
- Alkali-activated binders: A review. Part 2. About materials and binders manufactureConstruction and Building Materials, 2008
- Alkali-activated binders: A reviewConstruction and Building Materials, 2008
- The role of inorganic polymer technology in the development of ‘green concrete’Cement and Concrete Research, 2007