Effect of the Combination of Low-Speed Drilling and Cooled Irrigation Fluid on Intraosseous Heat Generation During Guided Surgical Implant Site Preparation
Authors:
- Ibrahim BarrakIBIbrahim Barrak
- Arpad Joób-FancsalyAJArpad Joób-Fancsaly
- Endre VargaEVEndre Varga
- Kristof BoaKBKristof Boa
- Jozsef PiffkoJPJozsef Piffko
- 1 August 2017
- journal article
- research article
- Published by Wolters Kluwer Health in Implant Dentistry
- Vol. 26 (4) , 541-546
Abstract
Investigating the effect of the combination of low-speed drilling and cooled irrigation fluid on intraosseous temperature rise during guided and freehand implant surgery. Bovine ribs were used as bone specimens. Grouping determinants were as follows: drill diameter (2.0, 2.5, 3.0, and 3.5 mm), irrigation fluid temperature (10°C, 15°C, and 20°C), and surgical method (guided and freehand). Drilling speed was 800 rpm. Results were compared with previous ones using 1200 rpm. Temperature measurements were conducted using K-type thermocouples. No mean temperature change exceeded 1.0°C if irrigation fluid cooled to 10°C was used, regardless of the drill diameter or the surgical method, with the highest elevation being 2.10°C. No significant reduction was measured when comparing groups using 15°C and 20°C irrigation fluids, regardless of both drill diameter and surgical method. The use of irrigation fluid being cooled to 10°C combined with low-speed drilling (800 rpm) seems to be a safe method for implant site preparation and drilling through a drilling guide in terms of temperature control.Keywords
This publication has 18 references indexed in Scilit:
- External cooling efficiently controls intraosseous temperature rise caused by drilling in a drilling guide system: an in vitro studyBritish Journal of Oral and Maxillofacial Surgery, 2015
- The effect of guided flapless implant procedure on heat generation from implant drillingJournal of Cranio-Maxillofacial Surgery, 2014
- A randomized clinical trial comparing guided implant surgery (bone‐ or mucosa‐supported) with mental navigation or the use of a pilot‐drill templateJournal of Clinical Periodontology, 2014
- Evaluation of Bone Heating, Drill Deformation, and Drill Roughness After Implant Osteotomy: Guided Surgery and Classic Drilling ProcedureThe International Journal of Oral and Maxillofacial Implants, 2014
- Internal Bone Temperature Change During Guided Surgery Preparations for Dental Implants: An In Vitro StudyThe International Journal of Oral and Maxillofacial Implants, 2013
- Effect of Surgical Drill Guide on Heat Generated From Implant DrillingJournal of Oral and Maxillofacial Surgery, 2009
- Effects of irrigation temperature on heat control in vitro at different drilling depthsClinical Oral Implants Research, 2009
- Temperatures during drilling for the placement of implants using the osseointegration techniqueJournal of Oral and Maxillofacial Surgery, 1986
- Heat caused by drilling cortical bone: Temperature measuredin vivoin patients and animalsActa Orthopaedica, 1984
- Thermal injury to boneInternational Journal of Oral Surgery, 1982