A Simple Model for Stable Cyclic Stress-Strain Relationship of Type 304 Stainless Steel Under Nonproportional Loading
- 5 February 1999
- journal article
- Published by ASME International in Journal of Engineering Materials and Technology
- Vol. 122 (1) , 1-9
Abstract
This paper proposes a simple two-surface model for cyclic incremental plasticity based on combined Mroz and Ziegler kinematic hardening rules under nonproportional loading. The model has only seven material constants and a nonproportional factor which describes the degree of additional hardening. Cyclic loading experiments with fourteen strain paths were conducted using Type 304 stainless steel. The simulation has shown that the model was precise enough to calculate the stable cyclic stress-strain relationship under nonproportional loadings. [S0094-4289(00)00101-8]Keywords
This publication has 24 references indexed in Scilit:
- Nonproportional Low Cycle Fatigue of 6061 Aluminum Alloy Under 14 Strain Paths1999
- Nonproportional Low Cycle Fatigue Criterion for Type 304 Stainless SteelJournal of Engineering Materials and Technology, 1995
- Effect of Stacking Fault Energy on Cyclic Constitutive Relation Under Nonproportional LoadingJournal of the Society of Materials Science, Japan, 1992
- Dislocation Substructures and Nonproportional HardeningJournal of Engineering Materials and Technology, 1990
- Constitutive Equations for Nonproportional Cyclic Elasto-ViscoplasticityJournal of Engineering Materials and Technology, 1987
- Multiaxial Fatigue Damage ModelsJournal of Engineering Materials and Technology, 1987
- A Two Surface Model for Transient Nonproportional Cyclic Plasticity, Part 2: Comparison of Theory With ExperimentsJournal of Applied Mechanics, 1985
- A Two Surface Model for Transient Nonproportional Cyclic Plasticity, Part 1: Development of Appropriate EquationsJournal of Applied Mechanics, 1985
- The Hardening and Rate-Dependent Behavior of Fully Annealed AISI Type 304 Stainless Steel Under Biaxial In-Phase and Out-of-Phase Strain Cycling at Room TemperatureJournal of Engineering Materials and Technology, 1984
- Comparison of the stress responses of an aluminum alloy tube to proportional and alternate axial and shear strain paths at room temperatureMechanics of Materials, 1983