Friction and Wear Behavior of Several Fe Matrix Alloys in Distilled Water
Authors:
- 9 October 2014
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 58 (1) , 97-105
Abstract
The tribological behaviors of Fe-Cr-B alloy and AISI52100 and AISI304 stainless steel sliding against an AISI52100 steel ball were investigated with a ball-on-disk tribotester under distilled water condition. The Fe-Cr-B alloy was successfully prepared by using powder metallurgy technology. In distilled water, the friction coefficient and specific wear rate of Fe-Cr-B alloy were the lowest compared to other specimens. The different alloys showed different wear mechanisms during the sliding process. The wear mechanism of AISI52100 steel was ploughing and severe plastic deformation; the wear mechanism of AISI304 stainless steel was ploughing and plastic deformation. However, Fe-Cr-B alloy was dominated by microploughs and slight delamination under distilled water condition. The Fe-Cr-B alloy showed better wear resistance than that of the other two alloys.Keywords
This publication has 34 references indexed in Scilit:
- Recent advances in emerging imaging techniques for non-destructive detection of food quality and safetyTrAC Trends in Analytical Chemistry, 2013
- Friction and wear behaviors of carbon-based multilayer coatings sliding against different rubbers in water environmentTribology International, 2013
- Effect of particle size on tribological behavior of Ni3Al matrix high temperature self-lubricating compositesTribology International, 2011
- Friction and wear properties of Babbitt alloy 16-16-2 under sea water environmentTribology International, 2011
- Multi-analytical investigation of stainless steel grade AISI 420 in simulated food contactJournal of Food Engineering, 2009
- Effect of Aramid Fiber and ZnO Nanoparticles on Friction and Wear of PTFE Composites in Dry and LN2ConditionsTribology Transactions, 2008
- Corrosion-induced release of chromium and iron from ferritic stainless steel grade AISI 430 in simulated food contactJournal of Food Engineering, 2008
- Sintering of 17-4PH stainless steel feedstock for metal injection moldingMaterials Letters, 2008
- Friction and wear properties of bronze–graphite composite under water lubricationTribology International, 2004
- Chemical contribution to friction behavior of sintered hexagonal boron nitride in waterWear, 2000