A Faster Active Package to Cell Balancing of Battery Management System Using Isolated CUK Converter with Switch Matrix
Open Access
- 30 September 2024
- journal article
- Published by Gazi Universitesi Fen Bilimleri Dergisi Part C: Tasarim ve Teknoloji in Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji
- Vol. 12 (3) , 639-661
Abstract
This paper proposes a faster active package to cell (P2C) balancing battery management system (BMS) by using a proportion-integration (PI) controlled isolated CUK converter (ICC) with a cell-selective switch matrix (SWM). The high power capability of the ICC and a SWM that has the ability to select each cell individually or multiple cells in series increase balance speed. In addition, the low cost analysis and small size comparisons of the proposed study are presented. BMS is applied to battery packs to monitor the voltage, current, temperature, and state of charge (SoC) values of each cell and provide the battery pack with the ability to operate in a safe zone. One of the battery problems is that each battery cell in the pack does not contribute energy equally to the entire pack. Li-ion batteries that are used in this paper also suffer from this problem due to their higher energy density than other batteries. Therefore, a balancing operation is needed for the voltage and SoC of each cell. According to the average of battery cells, the entire pack charges the selected lower cells by converting the energy through ICC and switching the lower energized cells. Due to the isolation, the energy can be transferred from pack to cell. The proposed study is simulated in MATLAB Simulink and then implemented experimentally. The experimental studies produce a balancing speed of 9.64 mV/min with 81.98% efficiency. Finally, the result of the proposed study is compared with the other P2C methods in the literature. The comparison also showed that the proposed study is a cost effective solution.Keywords
This publication has 39 references indexed in Scilit:
- Isolated bidirectional DC-DC Converter: A topological reviewe-Prime - Advances in Electrical Engineering, Electronics and Energy, 2024
- A critical review of battery cell balancing techniques, optimal design, converter topologies, and performance evaluation for optimizing storage system in electric vehiclesEnergy Reports, 2024
- Doping strategies for enhancing the performance of lithium nickel manganese cobalt oxide cathode materials in lithium-ion batteriesEnergy Storage Materials, 2023
- Lithium-ion battery state-of-charge balancing circuit using single resonant converter for electric vehicle applicationsJournal of Energy Storage, 2023
- Rechargeable batteries: Technological advancement, challenges, current and emerging applicationsEnergy, 2022
- Rechargeable Batteries of the Future—The State of the Art from a BATTERY 2030+ PerspectiveAdvanced Energy Materials, 2021
- A review of equalization strategies for series battery packs: variables, objectives, and algorithmsRenewable and Sustainable Energy Reviews, 2019
- Commercialization of Lithium Battery Technologies for Electric VehiclesAdvanced Energy Materials, 2019
- A review of rechargeable batteries for portable electronic devicesInfoMat, 2019
- A review of lithium-ion battery state of charge estimation and management system in electric vehicle applications: Challenges and recommendationsRenewable and Sustainable Energy Reviews, 2017