Effect of Palladium Coatings on the Corrosion Potential of Stainless Steel in High-Temperature Water Containing Dissolved Hydrogen and Oxygen
Author:
- 1 March 1991
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 47 (3) , 162-169
Abstract
The electrochemical behavior of untreated 316 (UNS(1) S31600) stainless steel and similar samples with thin coatings of palladium are compared in high-temperature water containing varying concentrations of hydrogen and oxygen. The differences in potentials are consistent with the hypothesis that the electrochemical recombination of hydrogen and oxygen on the surface controls the corrosion potential (mixed potential) of the sample. Palladium coatings as thin as 0.03 μm result in marked improvement in the response to hydrogen water chemistry (HWC) in lowering the corrosion potential below the critical value for protection against stress corrosion cracking (SCC) even at relatively low hydrogen injection rates and high residual oxygen concentrations. Because the diffusion coefficient of hydrogen is greater than that of oxygen, the protection potential can be achieved with hydrogen: oxygen ratios in the bulk water below the stoichiometric ratio of 2.0 required to form water. Constant extension rate tests (CERTs) clearly demonstrate that under these conditions, SCC can be readily suppressed. The behavior with palladium is representative of that to be anticipated from any of the platinum metals.Keywords
This publication has 10 references indexed in Scilit:
- Thin films to impede the incorporation of radionuclides in austenitic stainless steelsThin Solid Films, 1989
- Corrosion Potentials and Corrosion Behavior of AISI 304 Stainless Steel in High-Temperature Water Containing Both Dissolved Hydrogen and OxygenCorrosion, 1986
- Materials Behavior in Alternate (Hydrogen) Water Chemistry in the Ringhals-1 Boiling Water ReactorCorrosion, 1986
- Monitoring pH and Corrosion Potentials in High Temperature Aqueous EnvironmentsCorrosion, 1985
- Effect of Sulfuric Acid, Oxygen, and Hydrogen in High Temperature Water on Stress Corrosion Cracking of Sensitized AISI 304 Stainless SteelCorrosion, 1984
- The diffusion coefficients of helium, hydrogen, oxygen and nitrogen in water determined from the permeability of a stagnant liquid layer in the quasi-steady stateChemical Engineering Science, 1984
- Use of a High Temperature pH Sensor as a “Pseudo‐Reference Electrode” in the Monitoring of Corrosion and Redox Potentials at 285°CJournal of the Electrochemical Society, 1982
- The Effect of Oxygen Temperature Combinations on the Stress Corrosion Susceptibility of Sensitized Type 304 Stainless Steel in High Purity WaterCorrosion, 1979
- External Reference Electrodes for Use in High Temperature Aqueous SystemsJournal of the Electrochemical Society, 1979
- Solubilities of Inert Gases in Water. 0° C. to Near the Critical Point of Water.Journal of Chemical & Engineering Data, 1960