Role of annealing twinning in microstructural evolution of high purity silver during friction stir welding
- 19 March 2019
- journal article
- research article
- Published by SAGE Publications in Science and Technology of Welding and Joining
- Vol. 24 (7) , 644-651
Abstract
Friction stir welding (FSW) with a relatively large heat input was applied to high purity Ag with a low stacking fault energy, which leads to profuse twinning. The microstructural evolution was examined along the material flow path during rapid cooling FSW. The frequent formation of annealing twinning induced by the heating caused the microstructural refinement, following the transformation from twin boundaries to normal high angle boundaries. The bulging of the high angle boundary, which is one of the typical mechanisms of discontinuous dynamic recrystallisation did not occur. Irrespective of the initial grain size, the grain size obtained after the FSW was approximately 8 µm due to the dynamic balance between the grain boundary migration and the annealing twin formation.Keywords
Funding Information
- New Energy and Industrial Technology Development Organization (future pioneering project)
This publication has 24 references indexed in Scilit:
- Partial recrystallization in the nugget zone of friction stir welded dual-phase Cu–Zn alloyPhilosophical Magazine, 2009
- Cube texture in hot-rolled aluminum alloy 1050 (AA1050)—nucleation and growth behaviorActa Materialia, 2008
- Friction stir welding of carbon steelsMaterials Science and Engineering: A, 2006
- Material flow in butt friction stir welds in AA2024-T3Acta Materialia, 2006
- Friction stir welding and processingMaterials Science and Engineering: R: Reports, 2005
- Grain structure formation during friction stir welding observed by the ‘stop action technique’Acta Materialia, 2005
- Texture formation during equal channel angular extrusion of fcc and bcc materials: comparison with simple shearMaterials Science and Engineering: A, 2005
- Development of grain structure during friction stir weldingScripta Materialia, 2004
- Tensile properties and fracture locations of friction-stir-welded joints of 2017-T351 aluminum alloyJournal of Materials Processing Technology, 2003
- Formation of annealing twins in f.c.c. crystalsActa Materialia, 1997