Recrystallization behaviour during annealing of cold-rolled Cu–5Fe–2Sn alloy
Authors:
- 13 May 2020
- journal article
- research article
- Published by SAGE Publications in Materials Science and Technology
- Vol. 36 (11) , 1162-1168
Abstract
The recrystallization behaviour during annealing of cold-rolled Cu–5Fe–2Sn alloy was clarified in this paper. The effects of annealing temperature and time on the microstructure and properties of the Cu–5Fe–2Sn alloy were investigated. The equations of electrical conductivity and recrystallization kinetics during annealing were obtained with Martition's rule and Avrami empirical formula. The variations of recrystallization volume fraction and the growth of recrystallization grain for Cu–5Fe–2Sn alloy after 40% cold rolling were discussed. The calculated conductivity and volume fraction of recrystallization have a good match with experimental results. The variations of the properties of annealed Cu–5Fe–2Sn alloy are attributed to the growth rate of recrystallization phase and the size of recrystallization grains.Keywords
Funding Information
- China Natural Science Foundation (51641406, 51574171)
- Foundation of Taiyuan University of Science and Technology (20152009)
This publication has 34 references indexed in Scilit:
- Approaches to Modeling of RecrystallizationMetals, 2011
- Phase transformation in Cu–Cr–Zr–Mg alloyMaterials Letters, 2007
- A JMAK-microhardness model for quantifying the kinetics of restoration mechanisms in inhomogeneous microstructureMaterials Science and Engineering: A, 2007
- The role of annealing twins during recrystallization of CuActa Materialia, 2007
- Patterned micropads made of copper nanowires on silicon substrate for application as chip to substrate interconnectsNanotechnology, 2007
- The development of an optimum manufacturing and material selection process for the fabrication of labyrinth seal stripsJournal of Materials Processing Technology, 2004
- Precipitation in Cu–Ni–Si–Zn alloy for lead frameMaterials Letters, 2003
- Heavily drawn Cu–Fe–Ag and Cu–Fe–Cr microcompositesJournal of Materials Processing Technology, 2001
- Modeling Dynamic Recrystallization Using Cellular AutomataScripta Materialia, 1998
- Effect of temperature on the strength and conductivity of a deformation processed Cu-20%Fe compositeJournal of Materials Science, 1992