SMA actuators for vibration control and experimental determination of model parameters dependent on ambient airflow velocity
Author:
- 5 April 2016
- journal article
- Published by IOP Publishing in Smart Materials and Structures
- Vol. 25 (5) , 055026
Abstract
This article demonstrates the practical applicability of a method of modelling shape memory alloys (SMAs) as actuators. For this study, a pair of SMA wires was installed in an antagonistic manner to form an actuator, and a linear differential equation that describes the behaviour of the actuator's generated force relative to its input voltage was derived for the limited range below the austenite onset temperature. In this range, hysteresis need not be considered, and the proposed SMA actuator can therefore be practically applied in linear control systems, which is significant because large deformations accompanied by hysteresis do not necessarily occur in most vibration control cases. When specific values of the parameters used in the differential equation were identified experimentally, it became clear that one of the parameters was dependent on ambient airflow velocity. The values of this dependent parameter were obtained using an additional SMA wire as a sensor. In these experiments, while the airflow distribution around the SMA wires was varied by changing the rotational speed of the fans in the wind tunnels, an input voltage was conveyed to the SMA actuator circuit, and the generated force was measured. In this way, the parameter dependent on airflow velocity was estimated in real time, and it was validated that the calculated force was consistent with the measured one.Keywords
This publication has 23 references indexed in Scilit:
- Active Length Control of Shape Memory Alloy Wires Using Reinforcement LearningJournal of Intelligent Material Systems and Structures, 2011
- A shape memory alloy-based tendon-driven actuation system for biomimetic artificial fingers, part I: design and evaluationRobotica, 2009
- Application on vibration control of rotor system with a kind of SMA model2007
- Investigation of vibration mitigation of stay cables incorporated with superelastic shape memory alloy dampersSmart Materials and Structures, 2007
- Design and control of a Nitinol wire actuated rotary servoSmart Materials and Structures, 2007
- New technological development of passive and active vibration control: analysis and testSmart Materials and Structures, 2005
- A Study of Dynamic Mass Damper with Shape Memory Alloy (Modelling for Hysteretic Damping)TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C, 2005
- An overview of vibration and seismic applications of NiTi shape memory alloySmart Materials and Structures, 2002
- Using NiTi SMA tendons for vibration control of coastal structuresSmart Materials and Structures, 2001
- Hysteresis Modeling of SMA Actuators for Control ApplicationsJournal of Intelligent Material Systems and Structures, 1998