Synthesis and characterization of highly textured polycrystalline AlN/TiN superlattice coatings
Authors:
- 1 November 1998
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 16 (6) , 3341-3347
Abstract
AlN/TiN multilayer coatings were synthesized by sputtering Al and Ti metal targets simultaneously in an Ar+N2 plasma using a dual-cathode unbalanced dc magnetron sputtering system. Two different power sources, rf and pulsed-dc, were employed for substrate bias. It was found that under a critical thickness for the AlN layer, the AlN/TiN coating with the AlN layers below a critical thickness exhibit a highly textured [111]-oriented superlattice structure. However, the rf-biased films have poor mechanical properties. Transmission electron microscopy (TEM) studies of the rf-biased films show columnar structure of large grains with weak links (amorphous-like material) between different columnar grains. In the pulsed-dc-biased films, however, we noticed a twofold increase in hardness, when the bilayer thickness is under ∼5 nm. The increase of the hardness coincides with the structure phase transition from a randomly oriented polycrystalline AlN/TiN thin film to a highly [111]-textured AlN/TiN thin film. X-ray diffraction and TEM studies indicate that in the highly [111]-textured multilayer films, AlN is in a nanostabilized cubic form. The critical thickness for AlN to form a nanostabilized cubic structure along [111] is less than about 2.5 nm. TEM studies on the highly textured films deposited with pulsed-dc bias showed a coherent growth of an AlN/TiN layered structure across the film and highly dense grain boundaries, which was achieved by using the low-energy ion bombardment induced by the pulsed-dc bias. The high hardness value of the coating with small bilayer thickness deposited with pulsed-dc bias is not only due to the formation of the nanometer-scale multilayer structure and nanometer-stabilized cubic form of AlN, but also due to the strongly bonded high-angle grain boundaries between different columnar grains.Keywords
This publication has 10 references indexed in Scilit:
- Stabilization of Cubic AlN in Epitaxial AlN/TiN SuperlatticesPhysical Review Letters, 1997
- Formation of cubic-A1N in TiN/A1N superlatticeSurface and Coatings Technology, 1996
- New Routes in the Preparation of Mechanically Hard FilmsScience, 1996
- Model of superlattice yield stress and hardness enhancementsJournal of Applied Physics, 1995
- Reactive unbalanced magnetron sputter deposition of polycrystalline TiN/NbN superlattice coatingsSurface and Coatings Technology, 1993
- Deposition and properties of polycrystalline TiN/NbN superlattice coatingsJournal of Vacuum Science & Technology A, 1992
- Growth, structure, and microhardness of epitaxial TiN/NbN superlatticesJournal of Materials Research, 1992
- High rate reactive sputtering process controlSurface and Coatings Technology, 1987
- Growth of single-crystal TiN/VN strained-layer superlattices with extremely high mechanical hardnessJournal of Applied Physics, 1987
- The ternary system titanium-aluminum-nitrogenJournal of Solid State Chemistry, 1984