Investigation of material removal rate (MRR) and wire wear ratio (WWR) for alloy Ti6Al4 V exposed to heat treatment processing in WEDM and optimization of parameters using Grey relational analysis
Author:
- 30 August 2016
- journal article
- Published by Walter de Gruyter GmbH in Materials Testing
- Vol. 58 (9) , 794-805
Abstract
The study examines the changes of the microstructural, mechanical and conductivity characteristics of the titanium alloy Ti6Al4 V as a result of heat treatment using wire electrical discharge machining, and their effect on machinability. By means of optical microscopy and scanning electron microscopy (SEM), analyses have been performed to determine various characteristics and additionally, microhardness and conductivity measurements have been conducted. Material removal rate (MRR) and wire wear ratio (WWR) values have been determined by using L18 Taguchi test design. The microstructures of the samples have been changed by thermal procedures. Results have been obtained by using the Grey relational analysis (GRA) optimization technique to solve the maximum MRR and minimum WWR values. The best (highest) MRR value is obtained from sample E which was water quenched in dual phase processing. The microstructure of this sample is composed of primary α and α’ phases. The best (lowest) WWR value is obtained from sample A.Keywords
This publication has 29 references indexed in Scilit:
- Parametric optimization for surface roughness, kerf and MRR in wire electrical discharge machining (WEDM) using Taguchi design of experimentJournal of Mechanical Science and Technology, 2013
- Grey Relational Analysis of Micro-EDM Machining of Ti-6Al-4V AlloyMaterials and Manufacturing Processes, 2012
- INVESTIGATING THE EFFECTS OF EDM PARAMETERS ON SURFACE INTEGRITY, MRR AND TWR IN MACHINING OF Ti–6Al–4VMachining Science and Technology, 2012
- Material Removal Rate, Kerf, and Surface Roughness of Tungsten Carbide Machined with Wire Electrical Discharge MachiningJournal of Materials Engineering and Performance, 2010
- Electrical discharge machining of titanium alloy (Ti–6Al–4V)Applied Surface Science, 2007
- A comparative study of surface integrity of Ti–6Al–4V alloy machined by EDM and AECGJournal of Materials Processing Technology, 2007
- Optimization of wire electrical discharge machining (WEDM) process parameters using Taguchi methodThe International Journal of Advanced Manufacturing Technology, 2006
- Multi response optimization of wire EDM operations using robust design of experimentsThe International Journal of Advanced Manufacturing Technology, 2005
- A study on kerf and material removal rate in wire electrical discharge machining based on Taguchi methodJournal of Materials Processing Technology, 2004
- Experimental study of wire electrical discharge machining of AISI D5 tool steelJournal of Materials Processing Technology, 2004