Genetic improvement for pulpwood and peeled veneer inEucalyptus nitens
- 1 September 2012
- journal article
- Published by Canadian Science Publishing in Canadian Journal of Forest Research
- Vol. 42 (9) , 1724-1732
Abstract
Genetic improvement of wood properties affecting the quality of pulpwood and peeled veneer products is of general interest to tree breeders worldwide. If the wood properties of Eucalyptus nitens (H. Deane & Maiden) Maiden are under genetic control and the correlations between them are favourable, it may be possible to breed to simultaneously improve the plantation resource for both products. Acoustic wave velocity (AWV) measured in standing trees can predict wood stiffness, basic density, and kraft pulp yield (KPY) and therefore has the potential for use in tree breeding programs. From an E. nitens progeny trial in Tasmania, 540 trees were selected for rotary peeling. Of the wood properties assessed, there were significant differences among races in diameter, stem straightness, standing-tree, log, and billet AWV, and near infrared predicted cellulose content (CC). All traits displayed significant within-race genetic variation, and genetic correlations between AWV and veneer sheet modulus of elasticity (MOE) and between AWV and KPY and CC were strongly positive and highly significant. A similar relationship was found between veneer sheet MOE and KPY and between diameter at breast height and veneer sheet MOE. Basic density was genetically correlated with AWV and veneer sheet MOE. Results indicate that it should be possible for breeders to simultaneously improve properties in pulpwood and peeled veneer products and that AWV measured in the standing tree shows promise as a breeding selection criterion for both pulpwood and peeled veneer products.Keywords
This publication has 19 references indexed in Scilit:
- Measurement of cellulose content, Kraft pulp yield and basic density in eucalypt woodmeal using multisite and multispecies near infra-red spectroscopic calibrationsSouthern Forests: a Journal of Forest Science, 2011
- A Multi-Site, Multi-Species near Infrared Calibration for the Prediction of Cellulose Content in Eucalypt WoodmealJournal of Near Infrared Spectroscopy, 2010
- Age trends in genetic parameters for growth and wood density in Eucalyptus globulusTree Genetics & Genomes, 2009
- Developing and evaluating a multisite and multispecies NIR calibration for the prediction of Kraft pulp yield in eucalyptsSouthern Forests: a Journal of Forest Science, 2009
- Solid-wood production from temperate eucalypt plantations: a Tasmanian case studySouthern Forests: a Journal of Forest Science, 2008
- Les variations longitudinales intra-arbre des propriétés papetières et du bois varient entre les génotypes d’Eucalyptus globulusAnnals of Forest Science, 2007
- Genetic variation in veneer quality and its correlation to growth in white spruceCanadian Journal of Forest Research, 2004
- Segregation of Eucalyptus dunnii logs using acousticsForest Ecology and Management, 2003
- Developing breeding objectives for australian beef cattle productionAnimal Science, 1989
- Asymptotic Properties of Maximum Likelihood Estimators and Likelihood Ratio Tests under Nonstandard ConditionsJournal of the American Statistical Association, 1987