Divalent Ion Exchange With Alkali
Authors:
- 1 August 1983
- journal article
- Published by Society of Petroleum Engineers (SPE) in Society of Petroleum Engineers Journal
- Vol. 23 (04) , 657-668
Abstract
Exchange of hardness ions is important in EOR with chemical additives. In both micellar/polymer and caustic flooding processes, multivalent ions released from rock surfaces can interact with anionic surfactants, rendering them preferentially oil soluble and/or insoluble in water. Because hardness cations are sparingly soluble and precipitate in alkaline solutions, such solutions may be more efficient as surfactant-flood preflushes than are softened brines. Multivalent ion precipitation may also occur in alkaline waterflooding. To permit design of such processes, this paper presents a chromatographic theory for simultaneous ion exchange with precipitation of divalent ions. Theoretical effluent histories and concentration profiles are presented for the cases of finite pulses and continuous injection of hydroxide ions into linear cores. Complete capture of the insoluble salt particles is assumed. Results are given for the case of instantaneous equilibration of the solution with the precipitate, as well as for the case of complete nonequilibrium, in which the solid precipitate does not redissolve. These two physical extremes predict field performance and laboratory results, respectively. Data for Berea sandstone and an argillaceous sand compare favorably with the proposed theory. The efficiency of alkaline preflushing is shown to depend on the exchange isotherm, initial divalent loading of the rock, injected pH and salinity, the solubility product of the precipitated salt, and pulse size. The effect of pulse size on complete equilibrium removal of hardness ions is reduced efficiency with increasing size until a critical volume approximating continuous injection is reached. Increasing injected pH and salinity provides a more favorable response. The theoretical model, when applied to field conditions, predicts redissolution zones that have not been previously recognized because solution residence times in laboratory columns are too short. Calculations show that precipitate redissolution by the low-pH solutions following alkaline pulses may introduce high concentrations of calcium behind the preflush where interference with micellar or polymer solutions is likely. These results suggest that reservoir preflush design from laboratory tests, while possible, must be made carefully.Keywords
This publication has 24 references indexed in Scilit:
- Alkaline Injection for Enhanced Oil Recovery - A Status ReportJournal of Petroleum Technology, 1983
- Cation Exchange in Chemical Flooding: Part 2--The Effect of Dispersion, Cation Exchange, and Polymer/Surfactant Adsorption on Chemical Flood EnvironmentSociety of Petroleum Engineers Journal, 1978
- Low Péclet number behavior of the transfer rate in packed bedsChemical Engineering Science, 1978
- Interrelation of Crude Oil and Rock Properties With the Recovery of Oil by Caustic WaterfloodingSociety of Petroleum Engineers Journal, 1977
- Theory of ion-complexing effects in ion-exchange column performanceThe Journal of Physical Chemistry, 1974
- Flow of Suspensions through Porous Media—Application to Deep FiltrationIndustrial & Engineering Chemistry, 1970
- Investigation of the Colloidal Hydrated Calcium Silicates. II. Solubility Relationships in the Calcium Oxide-Silica-Water System at 25°The Journal of Physical Chemistry, 1965
- INVESTIGATION OF COLLOIDAL HYDRATED CALCIUM SILICATES. I. SOLUBILITY PRODUCTSThe Journal of Physical Chemistry, 1960
- Method of Characteristics Technique. Application to Heat and Mass Transfer ProblemsIndustrial & Engineering Chemistry, 1956
- THE SOLUBILITY OF CALCIUM HYDROXIDE IN AQUEOUS SALT SOLUTIONSJournal of the American Chemical Society, 1931