Contrasting Cooling Rates in the Lower Oceanic Crust at Fast- and Slow-spreading Ridges Revealed by Geospeedometry
Open Access
- 9 October 2007
- journal article
- research article
- Published by Oxford University Press (OUP) in Journal of Petrology
- Vol. 48 (11) , 2211-2231
Abstract
Two approaches to determining the high-temperature (∼1000°C to ∼600°C) cooling rate of the lower oceanic crust and upper mantle are presented and critically evaluated. The first is based on the down-temperature diffusive exchange of Ca between olivine and clinopyroxene. The second, less well-constrained, approach is based on the down-temperature diffusive exchange of Mg and Fe between olivine and spinel. Cooling rates based on olivine–spinel geospeedometry are approximately an order of magnitude faster than those from Ca-in-olivine geospeedometry. In contrast, cooling rates derived from thermochronology and remanent magnetism are approximately an order of magnitude slower than those derived by Ca-in-olivine geospeedometry; this is probably because they record cooling at lower temperatures. Using the Ca-in-olivine geospeedometer, the cooling rate of samples from the lower oceanic crust and upper oceanic mantle formed in the Oman ophiolite and in the three main ocean basins has been determined. Samples from the lower oceanic crust formed at fast-spreading ridges show a large decrease in cooling rate between the top and base of the gabbroic section, with most of the variation occurring within the upper kilometre. This is consistent with vertical heat loss (within the crustal frame of reference) dominating the thermal evolution at fast-spreading ridges. Samples from Ocean Drilling Program Hole 735B, which formed at the slow-spreading Southwest Indian Ridge, show no variation in cooling rate over 1500 m depth range and cooled substantially faster than rocks from the deeper portion of the gabbros in the Oman ophiolite, where the change in cooling rate with depth is limited. These observations are consistent with heat loss from small plutons emplaced in cool lithosphere at the slow-spreading ridge. Alternatively, they could be explained by cooling through the Ca-in-olivine closure interval during uplift towards the surface.Keywords
This publication has 69 references indexed in Scilit:
- The Fe3+/ΣFe ratios of MORB glasses and their implications for mantle meltingGeochimica et Cosmochimica Acta, 2005
- Serpentinization and heat generation: constraints from Lost City and Rainbow hydrothermal systems 1 1Associate editor: J. C. AltGeochimica et Cosmochimica Acta, 2004
- Symplectic Reaction in Olivine and the Controls of Intergrowth Spacing in SymplectitesJournal of Petrology, 2000
- Rates and mechanisms of Fe‐Mg interdiffusion in olivine at 980°–1300°CJournal of Geophysical Research, 1997
- Magma chambers in the Oman ophiolite: fed from the top and the bottomEarth and Planetary Science Letters, 1996
- Proceedings of the Ocean Drilling Program, 153 Initial Reports1995
- Cumulate Recycling and Crustal Evolution in the Bay of Islands OphioliteThe Journal of Geology, 1991
- High pressure experimental calibration of the olivine-orthopyroxene-spinel oxygen geobarometer: implications for the oxidation state of the upper mantleContributions to Mineralogy and Petrology, 1991
- Oxidation state of mantle xenoliths from British Columbia, CanadaContributions to Mineralogy and Petrology, 1990
- A simple magma-driven thermal balance model for the formation of volcanogenic massive sulphidesEarth and Planetary Science Letters, 1985