Decoration of sulfur with porous metal nanostructures: an alternative strategy for improving the cyclability of sulfur cathode materials for advanced lithium–sulfur batteries
Authors:
- 10 April 2013
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 49 (40) , 4513-4515
Abstract
Porous Pt nanostructure decorated sulfur microparticles (Pt@S) are fabricated using sulfur as the template. The Pt@S electrode shows a higher volumetric specific capacity of 520 mA h cm−3 and improved cyclability with only 15% capacity fading after 80 cycles at 0.1 C (167.5 mA g−1).Keywords
This publication has 22 references indexed in Scilit:
- A Polyaniline‐Coated Sulfur/Carbon Composite with an Enhanced High‐Rate Capability as a Cathode Material for Lithium/Sulfur BatteriesAdvanced Energy Materials, 2012
- Orthorhombic Bipyramidal Sulfur Coated with Polypyrrole Nanolayers As a Cathode Material for Lithium–Sulfur BatteriesThe Journal of Physical Chemistry C, 2012
- Improving the Performance of Lithium–Sulfur Batteries by Conductive Polymer CoatingACS Nano, 2011
- Enhanced Cyclability for Sulfur Cathode Achieved by a Water-Soluble BinderThe Journal of Physical Chemistry C, 2011
- Reversibility of electrochemical reactions of sulfur supported on inverse opal carbon in glyme–Li salt molten complex electrolytesChemical Communications, 2011
- New approaches to improve cycle life characteristics of lithium–sulfur cellsElectrochemistry Communications, 2007
- Discharge behavior of lithium/sulfur cell with TEGDME based electrolyte at low temperatureJournal of Power Sources, 2006
- Polysulfide Shuttle Study in the Li/S Battery SystemJournal of the Electrochemical Society, 2004
- The Lithium/Sulfur Rechargeable CellJournal of the Electrochemical Society, 2002
- Structural instability of ultrafine particles of metalsPhysical Review Letters, 1986