Solid-state recycling of wrought AA5083 aluminium chips via friction screw extrusion: microstructure and mechanical properties
Authors:
- Martin LuckabauerMLMartin Luckabauer
- Wessel EikelboomWEWessel Eikelboom
- Nick HelthuisNHNick Helthuis
- Saed RezaeinejadSRSaed Rezaeinejad
- Ton BorTBTon Bor
- Remko AkkermanRARemko Akkerman
Preprint
- 7 July 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
Solid-state recycling of aluminium machining chips via rotating-screw extrusion has so far been demonstrated only for heat-treatable cast and additive-manufacturing alloys, where post-process aging recovers strength after consolidation. We extend this process family to wrought, non-heat-treatable AA5083 where no aging treatment is available, and any strength recovery must occur within the single thermomechanical cycle of the extrusion step itself. Machining chips of AA5083-H111 were cold pre-compacted into 8 mm billets and consolidated via friction screw extrusion (FScE), a rotating-screw process, into a continuous 5 mm extrudate. Light microscopy, SEM-EDX and EBSD confirmed full consolidation with a fine equiaxed microstructure of ∼7–8 μm grain size, randomised crystallographic texture, dispersed Al6(Mn,Fe) intergranular particles and no continuous oxide films at consolidation interfaces. Mechanical testing showed retention of 92% of the wrought ultimate tensile strength (329 vs. 357 MPa) and 80% of the wrought yield strength, accompanied by a 35% increase in elongation at break. The yield-strength drop is observed equally in FScE-processed solid feedstock, identifying it as a feature of the FScE thermomechanical cycle rather than of chip recycling. No grain-boundary β-phase enrichment is detected, suggesting limited sensitisation risk. The results establish FScE as a viable solid-state recycling route for wrought Al-Mg chips and indicate a direct path to continuous operation via coupling with continuous chip-feed extruders.Keywords
This publication has 19 references indexed in Scilit:
- Exploring the feasibility of a closed-loop industrial symbiosis link through Friction Stir Extrusion-based Additive ManufacturingCIRP Annals, 2025
- Improving the Industrial Efficiency of Recycling Aluminum Alloy Chips Using Friction Stir Extrusion: Thin Wires Production ProcessInternational Journal of Precision Engineering and Manufacturing-Green Technology, 2024
- Additive friction stir deposition-enabled upcycling of automotive cast aluminum chipsAdditive Manufacturing Letters, 2022
- The effect of reversion heat treatment on the degree of sensitisation for aluminium alloy AA5083Corrosion Science, 2017
- Control of second-phase particles in the Al-Mg-Mn alloy AA 5083Journal of Alloys and Compounds, 2016
- Environmental assessment of solid state recycling routes for aluminium alloys: Can solid state processes significantly reduce the environmental impact of aluminium recycling?CIRP Annals, 2015
- Using contrast material techniques to determine metal flow in screw extrusion of aluminiumJournal of Materials Processing Technology, 2013
- Solid-state recycling of aluminium alloy swarf through cold profile extrusion and cold rollingJournal of Materials Processing Technology, 2011
- Production of wire via friction extrusion of aluminum alloy machining chipsJournal of Materials Processing Technology, 2010
- Hot profile extrusion of AA-6060 aluminum chipsJournal of Materials Processing Technology, 2009