Oxygenates screening for AdvancedPetroleum-Based Diesel Fuels: Part 2. The Effect of Oxygenate Blending Compounds on Exhaust Emissions
Authors:
- 24 September 2001
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
Adding oxygenates to diesel fuel has shown the potential for reducing particulate (PM) emissions in the exhaust. The objective of this study was to select the most promising oxygenate compounds as blending components in diesel fuel for advanced engine testing. A fuel matrix was designed to consider the effect of molecular structure and boiling point on the ability of oxygenates to reduce engine-out exhaust emissions from a modern diesel engine. Nine test fuels including a low-sulfur (∼1 ppm), low-aromatic hydrocracked base fuel and 8 oxygenate-base fuel blends were utilized. All oxygenated fuels were formulated to contain 7% wt. of oxygen. A DaimlerChrysler OM611 CIDI engine for light-duty vehicles was controlled with a SwRI Rapid Prototyping Electronic Control System. The base fuel was evaluated in four speed-load modes and oxygenated blends only in one mode. Each operating mode and fuel combination was run in triplicate. The Bosch smoke number, total PM, total volatile fraction (TVF), NOx, CO, THC, CO2, and O2 were measured. Dry PM, which is assumed to form during the combustion process, was calculated by subtracting the TVF from the total PM. PM emissions reductions were proportional to the oxygen content of the fuel, averaging 26.1 percent below that of base fuel. Spread in the dry PM emissions indicated that fuel properties other than oxygen content play a role in the soot formation mechanism. In some cases, NOx emissions can increase significantly. Based on Total PM emissions and other considerations, Tripropylene Glycol Mono-Methyl Ether and Di Butyl Maleate were identified as the most promising candidate oxygenate compounds for future engine testing.Keywords
This publication has 13 references indexed in Scilit:
- Dimethoxy Methane in Diesel Fuel: Part 1. The Effect of Fuels and Engine Operating Modes on Emissions of Toxic Air Pollutants and Gas/Solid Phase PAHSAE International Journal of Advances and Current Practices in Mobility, 2001
- Emissions Comparison of Alternative Fuels in an Advanced Automotive Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 2000
- Effects of oxygenated blending compounds on emissions from a turbocharged direct injection diesel engineInternational Journal of Engine Research, 2000
- Potentiality of Oxygenated Synthetic Fuel and Reformulated Fuel on Emissions from a Modern DI Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 1999
- Effects of Structure and Boiling Point of Oxygenated Blending Compounds in Reducing Diesel EmissionsSAE International Journal of Advances and Current Practices in Mobility, 1999
- A Comparison of Emissions from Clean Diesel FuelsSAE International Journal of Advances and Current Practices in Mobility, 1999
- Effects of DGM and Oxidation Catalyst on Diesel Exhaust EmissionsSAE International Journal of Advances and Current Practices in Mobility, 1999
- Effect of Several Oxygenates on Regulated Emissions from Heavy-Duty Diesel EnginesEnvironmental Science & Technology, 1997
- Application of Methods for Determining Total Organic Contribution to Diesel ParticulatesJournal of Engineering for Gas Turbines and Power, 1992
- Sooting Correlations for Premixed FlamesCombustion Science and Technology, 1984