The Changing and Distribution Laws of Oxygen Transfer Efficiency in the Full-Scale IFAS Process
Open Access
Abstract
The integrated fixed-film activated sludge (IFAS) process has been widely used in the upgrading of wastewater treatment plants (WWTPs). The oxygen transfer efficiency (αOTE) is of great significance to the design and operation of the IFAS process. The carrier filling ratio (CFR) and aeration type are two critical factors affecting αOTE and standard oxygen transfer efficiency (αSOTE). However, the distribution and changing laws of αOTE and αSOTE in the full-scale IFAS process areunclear. To optimize the operation of a WWTP and to improve the αOTE of the aeration systems, several off-gas tests were conducted under different aeration types and different CFRs. The results show that for the aerobic tank investigated (the ratio of length and width was 8:1), the αOTE and the αSOTE of the middle of the aeration systems were higher than those of the other two sides. However, the reason for the low αOTE at the beginning and the end of the tank may be different. Coarse-bubble aeration systems had a lower αOTE and almost the same oxygenation capacity (αSOTE) as the fine-bubble aeration systems under constant CFR (43%). The average αSOTE (18.7–28.9%) of the hybrid aeration systems increased with increasing CFR (7.7–57.7%), and different locations exhibited different degrees of change. The results reveal the distribution and changing law of the αOTE of aeration systems in the IFAS process, and attention should be paid to the improvement of the OTE of the plug-flow IFAS process.Keywords
Funding Information
- Ministry of Science and Technology of the People's Republic of China (2017ZX07101-002-005)
This publication has 41 references indexed in Scilit:
- A Critical Review of the Factors Affecting Modeling Oxygen Transfer by Fine‐Pore Diffusers in Activated SludgeWater Environment Research, 2018
- The influence of solid retention time on IFAS-MBR systems: analysis of system behaviorEnvironmental Technology, 2018
- Enhancing nitrogen removal efficiency and reducing nitrate liquor recirculation ratio by improving simultaneous nitrification and denitrification in integrated fixed-film activated sludge (IFAS) processWater Science & Technology, 2015
- Oxygen transfer and uptake, nutrient removal, and energy footprint of parallel full-scale IFAS and activated sludge processesWater Research, 2011
- Hybrid activated sludge/biofilm process for the treatment of municipal wastewater in a cold climate region: a case studyWater Science & Technology, 2011
- Optimizing aeration rates for minimizing membrane fouling and its effect on sludge characteristics in a moving bed membrane bioreactorJournal of Hazardous Materials, 2011
- The influence of aeration intensity on predation and EPS production in membrane bioreactorsWater Research, 2010
- DESIGN AND OPERATION OF NUTRIENT REMOVAL PLANTS FOR VERY LOW EFFLUENT CONCENTRATIONSProceedings of the Water Environment Federation, 2007
- Tracking particle size distributions in a moving bed biofilm membrane reactor for treatment of municipal wastewaterWater Science & Technology, 2006
- A new moving bed biofilm reactor - applications and resultsWater Science & Technology, 1994