Challenges in calibration of water distribution network: a case study of Ramnagar Elevated Service Reservoir command area in Nagpur City, India
Authors:
- 23 March 2020
- journal article
- research article
- Published by IWA Publishing in Water Supply
- Vol. 20 (4) , 1294-1312
Abstract
Calibration of a hydraulic model is a challenging task as it considers the involvement of a large number of uncertain parameters. There are some parameters like length and diameter of pipes, for which fairly accurate values can be obtained. As with all hydraulic models, water demands are one of the main parameters that cause the most uncertainty in the model outputs. The calibration of the water demands is usually not feasible, which is attributable to the limited quantity of available measurements in most real water networks. However, some parameters like nodal demands and pipe roughness coefficients are estimated close to the actual values. Various types of valves are used for flow control by throttling. Hence, their setting in the field is also an important input to the model. Having more precise data helps in reducing time and results in better calibration as presented in the case study of one hydraulic zone served from Ramnagar Elevated Service Reservoir (ESR) (Zone II) in Nagpur City, Maharashtra State, India. This paper aims at presenting the complexities and challenges involved in calibration of the study area. It further describes the entire process from collection of the required data to the calibration of the network.Keywords
This publication has 33 references indexed in Scilit:
- Calibration of Water Demand Multipliers in Water Distribution Systems Using Genetic AlgorithmsJournal of Water Resources Planning and Management, 2016
- Uncertainty Analysis of Transient Flow Modeling and Transient-Based Leak Detection in Elastic Water Pipeline SystemsWater Resources Management, 2015
- A genetic algorithm for demand pattern and leakage estimation in a water distribution networkJournal of Water Supply: Research and Technology—AQUA, 2014
- A New Method for Simultaneous Calibration of Demand Pattern and Hazen-Williams Coefficients in Water Distribution SystemsWater Resources Management, 2014
- Probabilistic Analysis of Transient Design for Water Supply SystemsJournal of Water Resources Planning and Management, 2010
- Simultaneous Zonation and Calibration of Pipe Network ParametersJournal of Hydraulic Engineering, 2003
- Parameter Estimation in Water‐Distribution Systems by Least SquaresJournal of Water Resources Planning and Management, 1994
- Explicit Calculation of Pipe‐Network ParametersJournal of Hydraulic Engineering, 1990
- Calibrating Water Distribution Network ModelsJournal of Environmental Engineering, 1988
- Calibrating Water System ModelsJournal AWWA, 1984