Compact bandpass filter with reconfigurable X‐band using stepped impedance resonator and folded structure
Open Access
- 23 March 2018
- journal article
- research article
- Published by Institution of Engineering and Technology (IET) in The Journal of Engineering
- Vol. 2018 (3) , 162-165
Abstract
A reconfigurable X‐band microstrip bandpass filter based on the stepped impedance resonator topology with two folded stubs is proposed. Reconfiguration is enabled in the microstrip filter using positive–intrinsic–negative (PIN) diode and the proposed filter performs frequency switching between uplink and downlink X‐band services. The prototype filter is realised ideally using open‐circuit and short‐circuit conditions that are designed in a way similar to the design using PIN diodes that provide the same results. From the simulation and measured results, it is inferred that by altering the ON/OFF states, the filter can work from downlink frequency range of 7.25–7.9 GHz to the uplink frequency range of 8.00–8.4 GHz. Comprehensive studies are conducted on a fabricated prototype to assess its performance from which encouraging results are obtained.Keywords
This publication has 7 references indexed in Scilit:
- A monolithic RF-MEMS filter with continuously-tunable center-frequency and bandwidth2011
- Wideband Bandpass Filter With Reconfigurable BandwidthIEEE Microwave and Wireless Components Letters, 2009
- High-$Q$ Fully Reconfigurable Tunable Bandpass FiltersIEEE Transactions on Microwave Theory and Techniques, 2009
- Design and simulation of 4-bit 10-14GHz RF MEMS tunable filter2009
- A New Class of Reconfigurable Microwave Bandpass FiltersIEEE Transactions on Circuits and Systems II: Express Briefs, 2008
- Bandpass filters with reconfigurable transmission zeros using varactor-tuned tapped stubsIEEE Microwave and Wireless Components Letters, 2006
- Bandpass Filters Using Parallel Coupled Stripline Stepped Impedance ResonatorsIEEE Transactions on Microwave Theory and Techniques, 1980