Effect of Humidity of Air on Hydrogen Absorption into Fe with Rust Layer Containing MgCl2 during Atmospheric Corrosion
Authors:
- 15 April 2021
- journal article
- research article
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 61 (4) , 1143-1150
Abstract
An Fe plate, whose one side was electro-polished and the other covered with the rust layer containing 25.7 g·m-2 MgCl2, was used as the specimen to investigate the effect of humidity on the hydrogen absorption of the plate. The specimen was subjected to an electrochemical hydrogen-absorption test during which the rusted surface was exposed to the air with controlled relative humidity (RH) and atmospheric corrosion occurred on it. When the rusted surface was subjected to dry (RH 0%)–wet (RH 27%) repeated cycle tests for 10.8 ks each, the anodic current density corresponding to the hydrogen-absorption rate was measured on the hydrogen detection surface. The maximum current density was almost independent of the cycle during the first 10 cycles, after which it decreased with an increase in the cycle, reaching almost a steady-state after about 40 cycles. After 55 cycles of the dry–wet repeated cycle test, the specimen was subjected to an electrochemical hydrogen-absorption test to obtain the relationship between the steady-state hydrogen-absorption rate and RH. Hydrogen absorption was observed at RH of about 15%, and the absorption rate increased rapidly with an increase in RH, reached a maximum at RH of about 30%, and then decreased rapidly. When RH increased beyond 40%, the absorption rate increased again, reached a maximum value at RH of 80%, and then decreased gradually. The specimen with the rust layer containing 39.8 g·m-2 MgCl2 also showed two peaks in the hydrogen-absorption rate versus RH plot.Keywords
This publication has 22 references indexed in Scilit:
- Evaluation of hydrogen absorption into steel in automobile moving environmentsCorrosion Science, 2015
- Hydrogen Entry and its Effect on Delayed Fracture Susceptibility of High Strength Steel Bolts under Atmospheric CorrosionISIJ International, 2012
- Hydrogen entry into Fe and high strength steels under simulated atmospheric corrosionElectrochimica Acta, 2011
- Evaluation of hydrogen entry into high strength steel under atmospheric corrosionCorrosion Science, 2010
- Pitting Corrosion of Bare Stainless Steel 304 under Chloride Solution DropletsJournal of the Electrochemical Society, 2010
- Assessment of protective function of steel rust layers by N2 adsorptionCorrosion Science, 2007
- Hydrogen entry into steel during atmospheric corrosion processCorrosion Science, 2005
- Initial Stage of Pitting Corrosion of Type 304 Stainless Steel under Thin Electrolyte Layers Containing Chloride IonsJournal of the Electrochemical Society, 2005
- Environmental Factors Affecting Hydrogen Absorption into SteelsCorrosion Engineering, 2005
- The Electrochemical Reduction of Rust Films on Weathering Steel SurfacesJournal of the Electrochemical Society, 1982