Use of Fused Deposition Modeling of Polyphenylsulfone for Centrifugal Casting of Polyurethane: Material, Surface, and Process Considerations
Authors:
- Thomas MartensTMThomas Martens
- Laine MearsLMLaine Mears
- Mike DotsonMDMike Dotson
- Monty GrahamMGMonty Graham
- Phillip SangerPSPhillip Sanger
- 22 September 2011
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 133 (5) , 051003
Abstract
For the development of a rotational symmetrical polyurethane part with a steel reinforcement, a requirement/constraint driven approach to process design has been taken. In this approach a scale model of the casting mold was built using fused deposition modeling rapid prototyping technique, then used to validate design, material and process parameters. After selection and testing on the scaled prototype, results were used to define a full-sized spin casting mold built using polyphenylsulfone material. This material was selected based on the process temperature and stress requirements. However, surface roughness in the as-built condition is unacceptable for demolding; this paper describes secondary processing to mitigate this effect. The result is a feasible process for manufacturing of centrifugal casting molds for polyurethane.Keywords
This publication has 9 references indexed in Scilit:
- Injection Molding of Degradable Interference Screws into Polymeric MoldMaterials Science Forum, 2010
- Rapid prototyping and manufacturing technology: Principle, representative technics, applications, and development trendsTsinghua Science and Technology, 2009
- Total Life Cycle-Based Materials Selection for Polymer Metal Hybrid Body-in-White Automotive ComponentsJournal of Materials Engineering and Performance, 2008
- A benchmark study on rapid prototyping processes and machines: Quantitative comparisons of mechanical properties, accuracy, roughness, speed, and material costProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2008
- Advantages of the centrifugal casting technique for the production of structural components with Al–Si alloysMaterials & Design (1980-2015), 2008
- Rapid prototyping driven design and realisation of large componentsRapid Prototyping Journal, 2007
- Rapid tooling: selective laser sintering injection toolingJournal of Materials Processing Technology, 2003
- Evaluation of inserts for modular thermoplastic injection moulds produced by spin castingJournal of Materials Processing Technology, 2001
- Rapid tooling technology. Part 1. A comparative studyThe International Journal of Advanced Manufacturing Technology, 1999